|
SIST EN 809:2000/kprA1:2009
01-maj-2009
ýUSDONHLQGHOLþUSDON]DWHNRþLQH6SORãQHYDUQRVWQH]DKWHYH
Pumps and pump units for liquids - Common safety requirements
Pumpen und Pumpenaggregate für Flüssigkeiten - Allgemeine sicherheitstechnische
Anforderungen
Pompes et groupes motopompes pour liquides - Prescriptions communes de sécurité
Ta slovenski standard je istoveten z: EN 809:1998/prA1
ICS:
23.080 ýUSDONH Pumps
SIST EN 809:2000/kprA1:2009 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 809:2000/kprA1:2009
---------------------- Page: 2 ----------------------
SIST EN 809:2000/kprA1:2009
EUROPEAN STANDARD
FINAL DRAFT
EN 809:1998
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
February 2009
ICS 23.080
English Version
Pumps and pump units for liquids - Common safety
requirements
Pompes et groupes motopompes pour liquides - Pumpen und Pumpenaggregate für Flüssigkeiten -
Prescriptions communes de sécurité Allgemeine sicherheitstechnische Anforderungen
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 197.
This draft amendment A1, if approved, will modify the European Standard EN 809:1998. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 809:1998/prA1:2009: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 809:2000/kprA1:2009
EN 809:1998/prA1:2009 (E)
Contents Page
Foreword .4
1 Modification to the Foreword .5
2 Modification to the Introduction .5
3 Modification to Clause 1, Scope .5
4 Modification to Clause 2,Normative references .6
5 Modification to Clause 3, Definitions .7
6 Modification to Clause 4, List of hazards .8
7 Modification to 5.1, General requirements . 10
8 Modification to 5.2.1.1, Crushing, cutting and entanglement . 11
9 Modification to 5.2.1.2.3, Permitted forces and moments on pipe connections . 11
10 Addition of 5.2.1.5, Lifting of pumps and pump units . 11
11 Modification to 5.2.2, Requirements to avoid electrical hazards . 12
12 Modification to 5.2.2.1, Electrical contact . 12
13 Modification to 5.2.2.3, External effects on electrical equipment . 12
14 Addition of 5.2.2.4, Electromagnetic compatibility . 12
15 Modification to 5.2.4.2, Requirements to avoid the danger of vibrations .
...