|
SIST EN 13032-1:2004/kFprA1:2011
01-september-2011
6YHWOREDLQUD]VYHWOMDYD0HUMHQMHLQSRGDMDQMHIRWRPHWULþQLKSRGDWNRYVYHWOREQLK
YLURYLQVYHWLONGHO 0HUMHQMHLQIRUPDWSRGDWNRY
Light and lighting - Measurement and presentation of photometric data of lamps and
luminaires - Part 1: Measurement and file format
Licht und Beleuchtung - Messung und Darstellung photometrischer Daten von Lampen
und Leuchten - Teil 1: Messung und Datenformat
Lumière et éclairage - Mesure et présentation des données photométriques des lampes
et des luminaires - Partie 1: Mesurage et format de données
Ta slovenski standard je istoveten z: EN 13032-1:2004/FprA1
ICS:
17.180.20 Barve in merjenje svetlobe Colours and measurement of
light
91.160.01 Razsvetljava na splošno Lighting in general
SIST EN 13032-1:2004/kFprA1:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 13032-1:2004/kFprA1:2011
---------------------- Page: 2 ----------------------
SIST EN 13032-1:2004/kFprA1:2011
EUROPEAN STANDARD
FINAL DRAFT
EN 13032-1:2004
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
July 2011
ICS 17.180.20; 29.140.01
English Version
Light and lighting - Measurement and presentation of
photometric data of lamps and luminaires - Part 1: Measurement
and file format
Lumière et éclairage - Mesure et présentation des données Licht und Beleuchtung - Messung und Darstellung
photométriques des lampes et des luminaires - Partie 1: photometrischer Daten von Lampen und Leuchten - Teil 1:
Mesurage et format de données Messung und Datenformat
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 169.
This draft amendment A1, if approved, will modify the European Standard EN 13032-1:2004. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13032-1:2004/FprA1:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 13032-1:2004/kFprA1:2011
EN 13032-1:2004/FprA1:2011 (E)
Contents Page
Foreword .3
1 Modification to the Foreword .4
2 Modification to the Introduction .4
3 Modification to Clause 2, Normative references .4
4 Modification to Clause 3, Terms and definitions .4
5 Modification to Clause 5, Laboratory requirements for tests .4
6 Addition of Annex F .5
2
---------------------- Page: 4 ----------------------
SIST EN 13032-1:2004/kFprA1:2011
EN 13032-1:2004/FprA1:2011 (E)
Foreword
This document (EN 13032-1:2004/FprA1:2011) has been prepared by Technical Committee CEN/TC 169
“Light and lighting”, the secretariat of which is held by DIN.
This docume
...