|
13785:2005/oprA1:2006
PREDSTANDARD
julij 2006
Regulatorji s pretokom do vključno 100 kg/h z največjim imenskim izhodnim
tlakom do vključno 4 bar, ki niso vključeni v SIST EN 12864, in s pripadajočimi
varnostnimi napravami za butan, propan ali njuni zmesi - Dopolnilo A1
Regulators with a capacity of up to and including 100 kg/h, having a maximum
nominal outlet pressure of up to and including 4 bar, other than those covered by
EN 12864 and their associated safety devices for butane, propane or their
mixtures - Amendment A1
ICS 23.060.40 Referenčna številka
SIST EN 13785:2005/oprA1:2006(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
EN 13785:2005
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
May 2006
ICS
English Version
Regulators with a capacity of up to and including 100 kg/h,
having a maximum nominal outlet pressure of up to and
including 4 bar, other than those covered by EN 12864 and their
associated safety devices for butane, propane or their mixtures
Détendeurs de débit inférieur ou égal à 100 kg/h, à Druckregelgeräte mit einem höchsten Ausgangsdruck bis
pression de détente nominale maximale inférieure ou égale einschließlich 4 bar und einem Durchfluss bis einschließlich
à 4 bar, autres que les détendeurs relevant de l'EN 12864, 100 kg/h, die nicht in EN 12864 geregelt sind, für Butan,
et leurs dispositifs de sécurité associés pour butane, Propan oder deren Gemische sowie die dazugehörigen
propane ou leurs mélanges Sicherheitseinrichtungen
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 181.
This draft amendment A1, if approved, will modify the European Standard EN 13785:2005. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status
as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2006 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13785:2005/prA1:2006: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
EN 13785:2005/prA1:2006 (E)
Foreword
This document (EN 13785:2005/prA1:2006) has been prepared by Technical Committee CEN/TC 181 “Dedicated
liquified petroluem gas appliances”, the secretariat of which is held by AFNOR.
This document is currently submitted to the CEN Enquiry.
This document has been elaborated mainly in order to :
- address the comments received during the formal vote on EN 13785:2005 and that was not taken into account
in the published version;
- take into account evolution of other standards written by CEN/TC 181WG8 (EN 12864, EN 13786 and their
amendments);
- include new CEN Members.
This document modifies or completes relevant clauses of EN 13785:2005, only the modified or completed clauses
are mentioned.
2
---------------------- Page: 3 ----------------------
EN 13785:2005/prA1:2006 (E)
2. Normative references
Add the following normative references
EN 12164, Copper and copper alloys - Rod for free machining purposes
EN 12165, Copper and copper alloys - Wrought and unwrought forging stock
EN ISO 7253, Paints and varnishes - Determination of resistance to neutral salt spray (fog)
3.1.5
quick coupling
Replace the text of the definition by the following one:
"connection system which allows the fitting of the regulator to the cylinder valve without a threaded
connection and without using tools"
3.1.6
tap
Replace the definition by the following one:
"3.1.6
tap (manual closing device)
device for closing the gas flow which requires an intentiona
...