EN 71-1:2005/FprA10

Safety of toys - Part 1: Mechanical and physical properties

EN 71-1:2005/FprA10

Name:EN 71-1:2005/FprA10   Standard name:Safety of toys - Part 1: Mechanical and physical properties
Standard number:EN 71-1:2005/FprA10   language:English language
Release Date:   technical committee:CEN/TC 52 - Safety of toys
Drafting committee:CEN/TC 52/WG 3 - Safety of toys - Mechanical, physical and general properties   ICS number:97.200.50 - Toys
SLOVENSKI STANDARD
SIST EN 71-1:2006/oprA10:2009
01-februar-2009
9DUQRVWLJUDþGHO0HKDQVNHLQIL]LNDOQHODVWQRVWL'RSROQLOR$
Safety of toys - Part 1: Mechanical and physical properties - Amendment A10
Sicherheit von Spielzeug - Teil 1: Mechanische und physikalische Eigenschaften
Sécurité des jouets - Partie 1 : Propriétés mécaniques et physiques - Amendement A10
Ta slovenski standard je istoveten z: EN 71-1:2005/prA10
ICS:
97.200.50 ,JUDþH Toys
SIST EN 71-1:2006/oprA10:2009 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 71-1:2006/oprA10:2009

---------------------- Page: 2 ----------------------

SIST EN 71-1:2006/oprA10:2009
EUROPEAN STANDARD
DRAFT
EN 71-1:2005
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA10
December 2008
ICS

English Version
Safety of toys - Part 1: Mechanical and physical properties
Sécurité des jouets - Partie 1: Propriétés mécaniques et Sicherheit von Spielzeug - Teil 1: Mechanische und
physiques physikalische Eigenschaften
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 52.
This draft amendment A10, if approved, will modify the European Standard EN 71-1:2005. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
: This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
Warning
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 71-1:2005/prA10:2008: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 71-1:2006/oprA10:2009
EN 71-1:2005/prA10:2008 (E)
Contents Page
Foreword .3
1 Modification to Clause 3 .4
2 Modification to clause 4 .6
4.23 Yo-yo balls (see A.51) .6
3 Modification to clause 5 .6
5.4 Cords and chains in toys (see A.29) .6
5.14 Straps intended to be used fully or partially around the neck .7
4 Modification to clause 8 .7
8.20 Cords cross-sectional dimension (see 5.4) .7
8.34 Test method to measure perimeter of cords and chains (see 5.4) .8
8.34.1 Test equipment .8
8.34.2 Test procedures .9
8.35 Yo-yo balls measurements (see 4.23) . 11
8.35.1 Measurement elastic constant “k” .
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27