|
SIST EN 1447:2009/kFprA1:2010
01-julij-2010
&HYQLVLVWHPLL]SROLPHUQLKPDWHULDORY&HYLL]GXURPHUQLKPDWHULDORYRMDþHQLKV
VWHNOHQLPLYODNQL *53 'RORþDQMHGROJRURþQHRGSRUQRVWLSURWLQRWUDQMHPXWODNX
Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes -
Determination of long-term resistance to internal pressure
Kunststoff-Rohrleitungssysteme - Rohre aus glasfaserverstärkten duroplastischen
Kunststoffen (GFK) - Bestimmung der Langzeit-Widerstandsfähigkeit gegen Innendruck
Systèmes de canalisations en plastiques - Tubes en plastiques thermodurcissables
renforcés de verre (PRV) - Détermination de la résistance à long terme à la pression
interne
Ta slovenski standard je istoveten z: EN 1447:2009/FprA1
ICS:
23.040.20 Cevi iz polimernih materialov Plastics pipes
83.120 2MDþDQLSROLPHUL Reinforced plastics
SIST EN 1447:2009/kFprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 1447:2009/kFprA1:2010
---------------------- Page: 2 ----------------------
SIST EN 1447:2009/kFprA1:2010
EUROPEAN STANDARD
FINAL DRAFT
EN 1447:2009
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
May 2010
ICS 23.040.20
English Version
Plastics piping systems - Glass-reinforced thermosetting plastics
(GRP) pipes - Determination of long-term resistance to internal
pressure
Systèmes de canalisations en plastiques - Tubes en Kunststoff-Rohrleitungssysteme - Rohre aus
plastiques thermodurcissables renforcés de verre (PRV) - glasfaserverstärkten duroplastischen Kunststoffen (GFK) -
Détermination de la résistance à long terme à la pression Bestimmung der Langzeit-Widerstandsfähigkeit gegen
interne Innendruck
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 155.
This draft amendment A1, if approved, will modify the European Standard EN 1447:2009. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ E
...