|
SIST EN 1012-2:2001/kprA1:2009
01-maj-2009
.RPSUHVRUMLLQYDNXXPVNHþUSDONH9DUQRVWQH]DKWHYHGHO 9DNXXPVNH
þUSDONH
Compressors and vacuum pumps - Safety requirements - Part 2: Vacuum pumps
Kompressoren und Vakuumpumpen - Sicherheitsanforderungen - Teil 2:
Vakuumpumpen
Compresseurs et pompes à vide - Prescriptions de sécurité - Partie 2: Pompes à vide
Ta slovenski standard je istoveten z: EN 1012-2:1996/prA1
ICS:
23.140 .RPSUHVRUMLLQSQHYPDWLþQL Compressors and pneumatic
VWURML machines
23.160 Vakumska tehnologija Vacuum technology
SIST EN 1012-2:2001/kprA1:2009 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 1012-2:2001/kprA1:2009
---------------------- Page: 2 ----------------------
SIST EN 1012-2:2001/kprA1:2009
EUROPEAN STANDARD
FINAL DRAFT
EN 1012-2:1996
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
February 2009
ICS 23.140; 23.160
English Version
Compressors and vacuum pumps - Safety requirements - Part 2:
Vacuum pumps
Compresseurs et pompes à vide - Prescriptions de sécurité Kompressoren und Vakuumpumpen -
- Partie 2: Pompes à vide Sicherheitsanforderungen - Teil 2: Vakuumpumpen
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 232.
This draft amendment A1, if approved, will modify the European Standard EN 1012-2:1996. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1012-2:1996/prA1:2009: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 1012-2:2001/kprA1:2009
EN 1012-2:1996/prA1:2009 (E)
Contents Page
Foreword .3
1 Addition of Introduction .4
2 Modification to Clause 2 .4
3 Modification to Clause 5 .4
4 Modifications to 6.2 .4
5 Modifications to 6.4 .5
6 Modification to 7.4 .5
7 Modification to 7.6.1 .5
8 Modification to Annex ZA .6
9 Addition of Annex ZB .7
2
---------------------- Page: 4 ----------------------
SIST EN 1012-2:2001/kprA1:2009
EN 1012-2:1996/prA1:2009 (E)
Foreword
This document (EN 1012-2:1996/prA1:2009) has been prepared has been prepared by Technical Committee
CEN/TC 232 “Compressors - Safety”, the secretariat of which is held by SIS.
This document is currently submitted to the Unique Acceptance Procedure.
This document has been prepared under a mandate given to CEN by the European
...