EN 14276-1:2006/FprA1

Pressure equipment for refrigerating systems and heat pumps - Part 1: Vessels - General requirements

EN 14276-1:2006/FprA1

Name:EN 14276-1:2006/FprA1   Standard name:Pressure equipment for refrigerating systems and heat pumps - Part 1: Vessels - General requirements
Standard number:EN 14276-1:2006/FprA1   language:English language
Release Date:   technical committee:CEN/TC 182 - Refrigerating systems, safety and environmental requirements
Drafting committee:CEN/TC 182/WG 7 - JWG CEN/TC 182/CEN/TC 54 Pressure vessels for refrigerating systems   ICS number:23.020.30 - Pressure vessels, gas cylinders
SLOVENSKI STANDARD
SIST EN 14276-1:2007/kprA1:2010
01-november-2010
7ODþQDRSUHPD]DKODGLOQHVLVWHPHLQWRSORWQHþUSDONHGHO3RVRGH6SORãQH
]DKWHYH
Pressure equipment for refrigerating systems and heat pumps - Part 1: Vessels -
General requirements
Druckgeräte für Kälteanlagen und Wärmepumpen - Teil 1: Behälter - Allgemeine
Anforderungen
Équipements sous pression pour systèmes de réfrigération et pompes à chaleur - Partie
1: Récipients - Exigences générales
Ta slovenski standard je istoveten z: EN 14276-1:2006/FprA1
ICS:
23.020.30 7ODþQHSRVRGHSOLQVNH Pressure vessels, gas
MHNOHQNH cylinders
27.080 7RSORWQHþUSDONH Heat pumps
27.200 Hladilna tehnologija Refrigerating technology
SIST EN 14276-1:2007/kprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 14276-1:2007/kprA1:2010

---------------------- Page: 2 ----------------------

SIST EN 14276-1:2007/kprA1:2010


EUROPEAN STANDARD
FINAL DRAFT
EN 14276-1:2006
NORME EUROPÉENNE

EUROPÄISCHE NORM
FprA1
August 2010
ICS 23.020.30; 27.080; 27.200
English Version
Pressure equipment for refrigerating systems and heat pumps -
Part 1: Vessels - General requirements
Équipements sous pression pour systèmes de réfrigération Druckgeräte für Kälteanlagen und Wärmepumpen - Teil 1:
et pompes à chaleur - Partie 1: Récipients - Exigences Behälter - Allgemeine Anforderungen
générales
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 182.

This draft amendment A1, if approved, will modify the European Standard EN 14276-1:2006. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.



Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 14276-1:2006/FprA1:2010: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 14276-1:2007/kprA1:2010
EN 14276-1:2006/FprA1:2010 (E)
Contents Page
Foreword .3
1 Modification of Clause 2, Normative references .4
2 Modification of Clause 3, Terms and definitions .5
3 Modification of 4.3.1.2 .5
4 Modification of 4.3.2, Cladding .5
5 Modification to 4.3.3.4 .6
6 Modification of 4.4.1, General .6
7 Modification of 4.4.2, Material requirements .6
8 Modification of 4.5, Material documentation .6
9 Modification of 5.2.1, Refrigerants .6
10 Modification of 5.2.2, Other fluids .6
11 Modification of 6.2.2, Internal corrosion .
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27