|
oSIST prEN 12604:2005
01-maj-2005
Vrata v industrijske in javne prostore ter garažna vrata - Mehanske lastnosti -
Zahteve
Industrial, commercial and garage doors and gates - Mechanical aspects - Requirements
Tore - Mechanische Aspekte - Anforderungen
Portes et portails industriels, commerciaux et de garage - Aspects mécaniques -
Exigences
Ta slovenski standard je istoveten z: prEN 12604
ICS:
91.060.50 Vrata in okna Doors and windows
91.090 Konstrukcije zunaj stavb External structures
oSIST prEN 12604:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 12604:2005
---------------------- Page: 2 ----------------------
oSIST prEN 12604:2005
EUROPEAN STANDARD
DRAFT
prEN 12604
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS Will supersede EN 12604:2000
English version
Industrial, commercial and garage doors and gates - Mechanical
aspects - Requirements
Portes industrielles, commercial et de garage - Aspects Tore - Mechanische Aspekte - Anforderungen
mécaniques - Exigences
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 33.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12604:2005: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 12604:2005
prEN 12604:2005 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope .5
2 Normative references .6
3 Terms and definitions .6
4 List of significant hazards .7
5 Safety Requirements and/or protective measures.7
6 Information .14
7 Verification .14
Annex A (normative) Mechanical hazards related to doors .15
Annex B (informative) Safeguarding against dropping by other design features incorporated in
the suspension system of vertically operating door leaves according to 4.3.4 .17
Annex C (informative) Examples of mechanical protection and safety distances .18
Annex D (informative) Relationship between requirements for mechanical aspects and relevant
test methods.19
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU D
...