|
SIST EN 12006-3:2000/kprA1:2009
01-marec-2009
1HDNWLYQLNLUXUãNLYVDGNLLPSODQWDWL3RVHEQH]DKWHYH]DVUþQRåLOQHYVDGNH
NDUGLRYDVNXODUQLLPSODQWDWLGHO=QRWUDMåLOQLSULSRPRþNL
Non active surgical implants - Particular requirements for cardiac and vascular implants -
Part 3: Endovascular devices
Nichtaktive chirurgische Implantate - Besondere Anforderungen an Herz- und
Gefäßimplantate - Teil 3: Endovaskuläre Implantate
Implants chirurgicaux non-actifs - Exigences particulières relatives aux implants
cardiaques et vasculaires - Partie 3: Dispositifs endovasculaires
Ta slovenski standard je istoveten z: EN 12006-3:1998/prA1
ICS:
11.040.40 Implantanti za kirurgijo, Implants for surgery,
protetiko in ortetiko prosthetics and orthotics
SIST EN 12006-3:2000/kprA1:2009 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 12006-3:2000/kprA1:2009
---------------------- Page: 2 ----------------------
SIST EN 12006-3:2000/kprA1:2009
EUROPEAN STANDARD
FINAL DRAFT
EN 12006-3:1998
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
December 2008
ICS 11.040.40
English Version
Non active surgical implants - Particular requirements for cardiac
and vascular implants - Part 3: Endovascular devices
Implants chirurgicaux non-actifs - Exigences particulières Nichtaktive chirurgische Implantate - Besondere
relatives aux implants cardiaques et vasculaires - Partie 3: Anforderungen an Herz- und Gefäßimplantate - Teil 3:
Dispositifs endovasculaires Endovaskuläre Implantate
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 285.
This draft amendment A1, if approved, will modify the European Standard EN 12006-3:1998. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
...