|
4:2002/OprA1:2004
PREDSTANDARD
december 2004
Neogrevane tlačne posode - 4. del: Proizvodnja
Unfired pressure vessels - Part 4: Fabrication
ICS 23.020.30 Referenčna številka
SIST EN 13445-4:2002/OprA1:2004(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
EN 13445-4:2002
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2004
ICS
English version
Unfired pressure vessels - Part 4: Fabrication
Récipients sous pression non soumis à la flamme – Unbefeuerte Druckbehälter - Teil 4: Herstellung
Partie 4 : Fabrication
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 54.
This draft amendment A1, if approved, will modify the European Standard EN 13445-4:2002. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status
as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is dis
...