|
SIST EN 131-2:2010+A1:2012/oprA2:2013
01-september-2013
/HVWYHGHO =DKWHYHSUHVNXãDQMHR]QDþHYDQMH
Ladders - Part 2: Requirements, testing, marking
Leitern - Teil 2: Anforderungen, Prüfung, Kennzeichnung
Echelles - Partie 2: Exigences, essais, marquage
Ta slovenski standard je istoveten z: EN 131-2:2010+A1:2012/prA2
ICS:
97.145 Lestve Ladders
SIST EN 131- en,fr,de
2:2010+A1:2012/oprA2:2013
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 131-2:2010+A1:2012/oprA2:2013
---------------------- Page: 2 ----------------------
SIST EN 131-2:2010+A1:2012/oprA2:2013
EUROPEAN STANDARD
DRAFT
EN 131-2:2010+A1:2012
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA2
June 2013
ICS 97.145
English Version
Ladders - Part 2: Requirements, testing, marking
Echelles - Partie 2: Exigences, essais, marquage Leitern - Teil 2: Anforderungen, Prüfung, Kennzeichnung
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 93.
This draft amendment A2, if approved, will modify the European Standard EN 131-2:2010+A1:2012. If this draft becomes an amendment,
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 131-2:2010+A1:2012/prA2:2013: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 131-2:2010+A1:2012/oprA2:2013
EN 131-2:2010+A1:2012/prA2:2013 (E)
Contents Page
Foreword .3
1 Modification of Foreword .4
2 Modification of Clause 2 Normative reference .4
3 Modification of 4.1 General .4
4 Modification of 4.9 Antiskid devices .4
5 Modification of 5.2 Strength test of stiles .4
6 Modification of 5.15 Torsion on ladder length .6
7 Add 5.17 Base slip test for leaning ladders .6
8 Add 5.18 Strength test for bar type stabilisers on leaning ladders .9
9 Add 5.19 Strength test for lateral type stabilisers on leaning ladders which are in the
plane of the ladder . 10
10 Add 5.20 Strength test for pole type stabilisers on leaning ladders which are not in the
plane of the ladder . 12
11 Modification of Table A.1 Test Sequence . 14
2
---------------------- Page: 4 ----------------
...