|
SLOVENSKI STANDARD
01-september-2017
Železniške naprave - Oznake železniških vozil - 1. del: Tovorni vagoni
Railway applications - Marking on railway vehicles - Part 1: Freight wagons
Bahnanwendungen - Kennzeichnung von Schienenfahrzeugen - Teil 1: Güterwagen
Applications ferroviaires - Inscriptions pour véhicules ferroviaires - Partie 1: Wagons pour
le fret
Ta slovenski standard je istoveten z: EN 15877-1:2012/prA1
ICS:
45.060.20 Železniški vagoni Trailing stock
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT
EUROPEAN STANDARD
EN 15877-1:2012
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
June 2017
ICS 45.060.20
English Version
Railway applications - Marking on railway vehicles - Part
1: Freight wagons
Applications ferroviaires - Inscriptions pour véhicules Bahnanwendungen - Kennzeichnung von
ferroviaires - Partie 1: Wagons pour le fret Schienenfahrzeugen - Teil 1: Güterwagen
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 256.
This draft amendment A1, if approved, will modify the European Standard EN 15877-1:2012. If this draft becomes an
amendment, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for
inclusion of this amendment into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 15877-1:2012/prA1:2017 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
1 Modification to the European foreword . 4
2 Modification to the Introduction . 4
3 Modification to 4.5.1 . 4
4 Modification to 4.5.30.2.7 . 8
4.1 Modification to Figure 67 . 8
4.2 Modification to the Key of Figure 67 . 10
5 Modification to 4.5.58 . 10
5.1 Modification to Figure 112 . 10
5.2 Modification to the Key of Figure 112 . 10
6 Modification to Annex ZA . 11
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 2008/57/EC aimed to be covered . 12
European foreword
This document (EN 15877-1:2012/prA1:2017) has been prepared by Technical Committee CEN/TC 256
“Railway applications”, the secretariat of which is held by DIN.
This document is currently submitted to the CEN Enquiry.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive 2008/57/EC.
For relationship with EU Directive 2008/57/EC, see informative Annex ZA, which is an integral part of
this document.
1 Modification to the European foreword
Change the 4th and 5th paragraph as follows:
“This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive 2008/57/EC.
For relationship with EU Directive 2008/57/EC, see informative Annex ZA, which is an integral part of
this document.”
2 Modification to the Introduction
Replace the first two bullet points of the 6th paragraph by:
“
— the Technical Specification for Interoperability Subsystem: Rolling Stock Scope: Freight Wagons as
published in published in the Official Journal L 104, 12.4.2013, p.1, and its amendments;
— the Technical
...