|
1:1999/oprA1:2006
PREDSTANDARD
september 2006
Kratkočlene okrogle verige za dvigovalne namene – Varnost – 1. del: Splošni
prevzemni pogoji
Short link chain for lifting purposes - Safety - Part 1: General conditions of
acceptance
ICS 53.020.30 Referenčna številka
SIST EN 818-1:1999/oprA1:2006(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
EN 818-1:1996
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
June 2006
ICS
English Version
Short link chain for lifting purposes - Safety - Part 1: General
conditions of acceptance
Chaînes de levage à maillons courts - Sécurité - Partie 1:
Conditions générales de réception
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 168.
This draft amendment A1, if approved, will modify the European Standard EN 818-1:1996. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status
as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2006 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 818-1:1996/prA1:2006: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
EN 818-1:1996/prA1:2006 (E)
Contents Page
Foreword 3
3 Definitions 4
4 Hazards 5
5 Safety requirements 5
6 Verification of safety requirements 5
9 Instructions for use 5
Figure A.1 Force / extension diagram 6
Annex ZA (informative) Relationship of this European Standard with EU Directives 7
2
---------------------- Page: 3 ----------------------
EN 818-1:1996/prA1:2006 (E)
Foreword
This document (EN 818-1:1996/prA1:2006) has been prepared by Technical Committee CEN/TC 168 “Chains,
ropes, webbing, slings and accessories - Safety”, the secretariat of which is held by BSI.
This document is currently submitted to the CEN Enquiry.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
...