|
SIST EN 13020:2005/kFprA1:2009
01-oktober-2009
6WURML]DREGHORYDQMHFHVWLãþ9DUQRVWQH]DKWHYH
Road surface treatment machines - Safety requirements
Maschinen für die Straßenoberflächenbehandlung - Sicherheitsanforderungen
Machines pour le traitement des surfaces routières - Prescriptions de sécurité
Ta slovenski standard je istoveten z: EN 13020:2004/FprA1
ICS:
93.080.10 Gradnja cest Road construction
SIST EN 13020:2005/kFprA1:2009 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 13020:2005/kFprA1:2009
---------------------- Page: 2 ----------------------
SIST EN 13020:2005/kFprA1:2009
EUROPEAN STANDARD
FINAL DRAFT
EN 13020:2004
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
August 2009
ICS 91.220
English Version
Road surface treatment machines - Safety requirements
Machines pour le traitement des surfaces routières - Maschinen für die Straßenoberflächenbehandlung -
Prescriptions de sécurité Sicherheitsanforderungen
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 151.
This draft amendment A1, if approved, will modify the European Standard EN 13020:2004. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13020:2004/FprA1:2009: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 13020:2005/kFprA1:2009
EN 13020:2004/FprA1:2009 (E)
Contents Page
Foreword .3
1 Modification to the Introduction .4
2 Modification to the Scope .4
3 Modification to Clause 2, Normative references .4
4 Modification to Clause 3, Terms and definitions .5
5 Modification to Clause 4, List of significant hazards .6
6 Modification to Clause 5, Safety requirements and/or measures .7
7 Modification to Clause 7, Information for use . 12
8 Modification to Clause 8, Marking. 12
9 Addition of a new Annex B . 13
10 Modification to Annex ZA . 17
11 Addition of a new Annex ZB . 18
12 Modification to the Bibliography . 18
2
---------------------- Page: 4 ----------------------
SIST EN 13020:2005/kFprA1:2009
EN 13020:2004/FprA1:2009 (E)
Foreword
This document (EN 13020:2004/FprA1:2009) has been prepared by Technical Committee CEN/TC 151
“Construction equipment and building material machines - Safety”, the secretariat of which is hel
...