EN ISO 4064-5:2017/A11:2022

Water meters for cold potable water and hot water - Part 5: Installation requirements (ISO 4064-5:2014)

EN ISO 4064-5:2017/A11:2022

Name:EN ISO 4064-5:2017/A11:2022   Standard name:Water meters for cold potable water and hot water - Part 5: Installation requirements (ISO 4064-5:2014)
Standard number:EN ISO 4064-5:2017/A11:2022   language:English language
Release Date:13-Dec-2022   technical committee:CEN/TC 92 - Test methods and equipment for cold water meters
Drafting committee:CEN/TC 92/WG 2 - General requirements   ICS number:91.140.60 - Water supply systems

SLOVENSKI STANDARD
01-marec-2023
Vodomeri za merjenje hladne pitne vode in vroče vode - 5. del: Zahteve za
vgradnjo - Dopolnilo A11 (ISO 4064-5:2014)
Water meters for cold potable water and hot water - Part 5: Installation requirements
(ISO 4064-5:2014)
Wasserzähler zum Messen von kaltem Trinkwasser und heißem Wasser - Teil 5:
Einbaubedingungen (ISO 4064-5:2014)
Compteurs d'eau potable froide et d'eau chaude - Partie 5: Exigences d'installation (ISO
4064-5:2014)
Ta slovenski standard je istoveten z: EN ISO 4064-5:2017/A11:2022
ICS:
17.120.10 Pretok v zaprtih vodih Flow in closed conduits
91.140.60 Sistemi za oskrbo z vodo Water supply systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN ISO 4064-5:2017/A11
EUROPEAN STANDARD
NORME EUROPÉENNE
December 2022
EUROPÄISCHE NORM
ICS 91.140.60
English Version
Water meters for cold potable water and hot water - Part
5: Installation requirements (ISO 4064-5:2014)
Compteurs d'eau potable froide et d'eau chaude - Wasserzähler zum Messen von kaltem Trinkwasser
Partie 5: Exigences d'installation (ISO 4064-5:2014) und heißem Wasser - Teil 5: Einbaubedingungen (ISO
4064-5:2014)
This amendment A11 modifies the European Standard EN ISO 4064-5:2017; it was approved by CEN on 26 October 2022.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 4064-5:2017/A11:2022 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the essential
requirements of Directive 2014/32/EU aimed to be covered . 4

European foreword
This document (EN ISO 4064-5:2017/A11:2022) has been prepared by Technical Committee CEN/TC 92
“Water meters” the secretariat of which is held by SNV.
This Amendment to the European Standard EN ISO 4064-5:2017 shall be given the status of a national
standard, either by publication of an identical text or by endorsement, at the latest by June 2023, and
conflicting national standards shall be withdrawn at the latest by June 2023.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent
rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directives.
For relationship with EU Directives, see informative Annex ZA, which is an integral part of this document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands,
Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
the United Kingdom.
Annex ZA
(informative)
R
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27