|
SIST EN 15502-2-1:2013/oprA1:2014
01-marec-2014
3OLQVNLNRWOL]DFHQWUDOQRJUHWMHGHO 3RVHEHQVWDQGDUG]DWLSNRWORY&LQWLSH
NRWORY%%LQ%]LPHQVNRPRþMRGRYNOMXþQRN:'RSROQLOR$
Gas-fired central heating boilers - Part 2-1: Specific standard for type C appliances and
type B2, B3 and B5 appliances of a nominal heat input not exceeding 1 000 kW
Heizkessel für gasförmige Brennstoffe - Teil 2-1: Heizkessel der Bauart C und
Heizkessel der Bauarten B2,B3 und B5 mit einer Nennwärmebelastung nicht größer als
1 000 kW
Chaudières de chauffage utilisant les combustibles gazeux - Partie 2-1: Norme
spécifique pour les appareils de type C et les appareils de types B2, B3 et B5 dont le
débit calorifique nominal est inférieur ou égal à 1 000 kW
Ta slovenski standard je istoveten z: EN 15502-2-1:2012/prA1
ICS:
91.140.10 Sistemi centralnega Central heating systems
ogrevanja
97.100.20 Plinski grelniki Gas heaters
SIST EN 15502-2-1:2013/oprA1:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 15502-2-1:2013/oprA1:2014
---------------------- Page: 2 ----------------------
SIST EN 15502-2-1:2013/oprA1:2014
EUROPEAN STANDARD
DRAFT
EN 15502-2-1:2012
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
February 2014
ICS 91.140.10; 27.060.30
English Version
Gas-fired central heating boilers - Part 2-1: Specific standard for
type C appliances and type B2, B3 and B5 appliances of a
nominal heat input not exceeding 1 000 kW
Combustibles de chauffage utilisant les combustibles Heizkessel für gasförmige Brennstoffe - Teil 2-1: Heizkessel
gazeux - Partie 2-1 : Norme spécifique pour les appareils der Bauart C und Heizkessel der Bauarten B2, B3 und B5
de type C et les appareils de types B2, B3 et B5 dont le mit einer Nennwärmebelastung nicht größer als 1 000 kW
débit calorifique nominal est inférieur ou égal à 1 000 kW
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 109.
This draft amendment A1, if approved, will modify the European Standard EN 15502-2-1:2012. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 15502-2-1:2012/prA1:2014 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 15502-2-1:2013/oprA1:2014
EN 15502-2-1:2012/prA1:2014 (E)
Contents
Page
Foreword .4
1 Modifications to the Foreword .4
2 Modifications to the Introduction .5
3 Modifications to '1 Scope' .5
4 Modifications to '3 Terms, definitions and symbols' .6
5 Modifications to '5 Construction' .8
6 Modifications to '8 Operational requirements'.
...