|
SIST EN 71-1:2011/oprA3:2012
01-december-2012
9DUQRVWLJUDþGHO 0HKDQVNHLQIL]LNDOQHODVWQRVWL'RSROQLOR$
Safety of toys - Part 1: Mechanical and physical properties - Amendment 3: Toy books
Sicherheit von Spielzeug - Teil 1: Mechanische und physikalische Eigenschaften
Sécurité des jouets - Partie 1: Propriétés mécaniques et physiques - Amendement 3:
Livres jouets
Ta slovenski standard je istoveten z: EN 71-1:2011/prA3
ICS:
97.200.50 ,JUDþH Toys
SIST EN 71-1:2011/oprA3:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 71-1:2011/oprA3:2012
---------------------- Page: 2 ----------------------
SIST EN 71-1:2011/oprA3:2012
EUROPEAN STANDARD
DRAFT
EN 71-1:2011
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA3
August 2012
ICS 97.200.50
English Version
Safety of toys - Part 1: Mechanical and physical properties -
Amendment 3: Toy books
Sicherheit von Spielzeug - Teil 1: Mechanische und
physikalische Eigenschaften
This draft amendment is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 52.
This draft amendment A3, if approved, will modify the European Standard EN 71-1:2011. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 71-1:2011/prA3:2012: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 71-1:2011/oprA3:2012
EN 71-1:2011/prA3:2012 (E)
Contents Page
Foreword .3
3 Terms and definitions .3
5.1 General requirements (see A.26) .3
6 Packaging (see A.56) .4
A.26 General requirements for toys intended for children under 36 months (see 5.1) .5
Bibliography .6
2
---------------------- Page: 4 ----------------------
SIST EN 71-1:2011/oprA3:2012
EN 71-1:2011/prA3:2012 (E)
Foreword
This document (EN 71-1:2011/prA3:2012) has been prepared by Technical Committee CEN/TC 52 “Safety of
toys”, the secretariat of which is held by DS.
This document is currently submitted to the CEN Enquiry.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
3 Terms and definitions
Change 3.38 to read as follows:
3.38
paper
sheet formed by irregularly intervened cellulose fibres with a mass per unit area of 400 g/m² or less
Add a new definition:
3.XX
paperboard
sheet formed by irregularly intervened cellulose fibres with a mass per unit area over 400 g/m² excluding
pressed wooden fibreboards such as medium density fibreboard (MDF), chipboard and materials with similar
properties
Note 1 to entry: The term paperboar
...