EN 1175-1:1998/FprA1

Safety of industrial trucks - Electrical requirements - Part 1: General requirements for battery powered trucks

EN 1175-1:1998/FprA1

Name:EN 1175-1:1998/FprA1   Standard name:Safety of industrial trucks - Electrical requirements - Part 1: General requirements for battery powered trucks
Standard number:EN 1175-1:1998/FprA1   language:English language
Release Date:   technical committee:CEN/TC 150 - Industrial trucks - Safety
Drafting committee:CEN/TC 150/WG 4 - Electrical matters   ICS number:53.060 - Industrial trucks
SLOVENSKI STANDARD
SIST EN 1175-1:1998/kFprA1:2010
01-julij-2010
9DUQRVWYR]LO]DWDOQLWUDQVSRUW(OHNWULþQH]DKWHYHGHO6SORãQH]DKWHYH]D
HOHNWULþQDYR]LOD]DWDOQLWUDQVSRUWQDEDWHULMVNLSRJRQ'RSROQLOR$
Safety of industrial trucks - Electrical requirements - Part 1: General requirements for
battery powered trucks
Sicherheit von Flurförderzeugen - Elektrische Anforderungen - Teil 1: Allgemeine
Anforderungen für Flurförderzeuge mit batterieelektrischem Antrieb
Sécurité des chariots de manutention - Prescriptions électriques - Partie 1: Prescriptions
générales des chariots alimentés par batterie
Ta slovenski standard je istoveten z: EN 1175-1:1998/FprA1
ICS:
43.120 (OHNWULþQDFHVWQDYR]LOD Electric road vehicles
53.060 Industrijski tovornjaki Industrial trucks
SIST EN 1175-1:1998/kFprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 1175-1:1998/kFprA1:2010

---------------------- Page: 2 ----------------------

SIST EN 1175-1:1998/kFprA1:2010


EUROPEAN STANDARD
FINAL DRAFT
EN 1175-1:1998
NORME EUROPÉENNE

EUROPÄISCHE NORM
prA1
March 2010
ICS 53.060
English Version
Safety of industrial trucks - Electrical requirements - Part 1:
General requirements for battery powered trucks
Sécurité des chariots de manutention - Prescriptions Sicherheit von Flurförderzeugen - Elektrische
électriques - Partie 1: Prescriptions générales des chariots Anforderungen - Teil 1: Allgemeine Anforderungen für
alimentés par batterie Flurförderzeuge mit batterieelektrischem Antrieb
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 150.

This draft amendment A1, if approved, will modify the European Standard EN 1175-1:1998. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.



Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1175-1:1998/FprA1:2010: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 1175-1:1998/kFprA1:2010
EN 1175-1:1998/FprA1:2010 (E)
Contents
Page
Foreword . 3
1 Modifications to the Foreword . 4
2 Modifications to the Introduction . 5
3 Modifications to Clause 1 ( Scope ) . 5
4 Modifications to Clause 2 ( Normative references ) . 5
5 Modifications to Clause 4 ( List of significant hazards ) . 6
6 Modification to 5.9.4 ( Pulse control travel systems ) . 6
7 Modification to 5.9.5 ( Prevention of travel ) . 6
8 Modification to 5.9.6 ( Steering control ) . 6
9 Modification to 5.9.7 ( Load handling control ) . 6
10 Modification to 5.9.8 ( Tiller control ) .
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27