|
oSIST prEN 12392:2008
01-september-2008
Aluminij in aluminijeve zlitine - Gnetne zlitine in zlitine za litje - Posebne zahteve za
aluminijeve izdelke za izdelavo naprav, ki delajo pod tlakom
Aluminium and aluminium alloys - Wrought and cast materials - Special requirements for
materials intended for pressure purpose
Aluminium und Aluminiumlegierungen - Knet- und Gusswerkstoffe - Besondere
Anforderungen an Werkstoffe für die Fertigung von Druckgeräten
Aluminium et alliages d'aluminium - Matériaux corroyés et moulés - Exigences
particulières pour les matériaux destinés à être utilisés sous pression
Ta slovenski standard je istoveten z: prEN 12392
ICS:
77.150.10 Aluminijski izdelki Aluminium products
oSIST prEN 12392:2008 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 12392:2008
---------------------- Page: 2 ----------------------
oSIST prEN 12392:2008
EUROPEAN STANDARD
DRAFT
prEN 12392
NORME EUROPÉENNE
EUROPÄISCHE NORM
June 2008
ICS 77.150.10 Will supersede EN 12392:2000
English Version
Aluminium and aluminium alloys - Wrought and cast materials -
Special requirements for materials intended for pressure
purpose
Aluminium et alliages d'aluminium - Matériaux corroyés et
moulés - Exigences particulières pour les matériaux
destinés à être utilisés sous pression
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 132.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12392:2008: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 12392:2008
prEN 12392:2008 (E)
Contents Page
Foreword.3
1 Scope.4
2 Normative references.4
3 Terms and definitions .5
4 Materials.6
5 Order documents.6
6 Product requirements.7
6.1 Production and manufacturing methods .7
6.2 Quality control.8
6.3 Chemical composition.8
6.4 Mechanical properties.8
6.5 Tolerances on dimensions and form.
...