EN ISO 18369-2:2006/prA1

Ophthalmic optics - Contact lenses - Part 2: Tolerances - Amendment 1 (ISO 18369-2:2006/DAM 1:2009)

EN ISO 18369-2:2006/prA1

Name:EN ISO 18369-2:2006/prA1   Standard name:Ophthalmic optics - Contact lenses - Part 2: Tolerances - Amendment 1 (ISO 18369-2:2006/DAM 1:2009)
Standard number:EN ISO 18369-2:2006/prA1   language:English language
Release Date:28-Mar-2010   technical committee:CEN/TC 170 - Ophthalmic optics
Drafting committee:CEN/TC 170 - Ophthalmic optics   ICS number:11.040.70 - Ophthalmic equipment
SLOVENSKI STANDARD
SIST EN ISO 18369-2:2006/oprA1:2010
01-marec-2010
2þHVQDRSWLND.RQWDNWQHOHþHGHO7ROHUDQFH'RSROQLOR$ ,62
'$0
Ophthalmic optics - Contact lenses - Part 2: Tolerances - Amendment 1 (ISO 18369-
2:2006/DAM 1:2009)
Augenoptik - Kontaktlinsen - Teil 2: Grenzabweichungen - Änderung 1 (ISO 18369-
2:2006/DAM 1:2009)
Optique ophtalmique - Lentilles de contact - Partie 2: Tolérances - Amendement 1 (ISO
18369-2:2006/DAM 1:2009)
Ta slovenski standard je istoveten z: EN ISO 18369-2:2006/prA1
ICS:
11.040.70 Oftalmološka oprema Ophthalmic equipment
SIST EN ISO 18369-2:2006/oprA1:2010 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010

---------------------- Page: 2 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010


EUROPEAN STANDARD
DRAFT
EN ISO 18369-2:2006
NORME EUROPÉENNE

EUROPÄISCHE NORM
prA1
December 2009
ICS 11.040.70
English Version
Ophthalmic optics - Contact lenses - Part 2: Tolerances -
Amendment 1 (ISO 18369-2:2006/DAM 1:2009)
Optique ophtalmique - Lentilles de contact - Partie 2: Augenoptik - Kontaktlinsen - Teil 2: Grenzabweichungen -
Tolérances - Amendement 1 (ISO 18369-2:2006/DAM Änderung 1 (ISO 18369-2:2006/DAM 1:2009)
1:2009)
This draft amendment is submitted to CEN members for third parallel enquiry. It has been drawn up by the Technical Committee CEN/TC
170.

This draft amendment A1, if approved, will modify the European Standard EN ISO 18369-2:2006. If this draft becomes an amendment,
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration.

This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 18369-2:2006/prA1:2009: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010
EN ISO 18369-2:2006/prA1:2009 (E)
Contents Page
Foreword .3
2

---------------------- Page: 4 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010
EN ISO 18369-2:2006/prA1:2009 (E)
Foreword
This Amendment (EN ISO 18369-2:2006/prA1:2009) has been prepared by Technical Committee ISO/TC 172
"Optics and photonics" in collaboration with Technical Committee CEN/TC 170 “Ophthalmic optics” the
secretariat of which is held by DIN.
This document is currently submitted to the third parallel CEN Enquiry.
Endorsement notice
The text of ISO 18369-2:2006/DAM 1:2009 has been approved by CEN as a EN ISO 18369-2:2006/prA1:2009
without any modification.


3

---------------------- Page: 5 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010

---------------------- Page: 6 ----------------------

SIST EN ISO 18369-2:2006/oprA1:2010
DRAFT AMENDMENT ISO 18369-2:2006/DAmd 1.3
ISO/TC 172/SC 7 Secretariat: DIN
Voting begins on: Voting terminates on:
2009-12-03 2010-02-03
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Ophthalmic optics — Contact lenses —
Part 2:
Tolerances
AMENDMENT 1
Optique ophtalmique — Lentilles de contact —
Partie 2: Tolérances
AMENDEMENT 1
ICS 11.040.70

ISO/CEN PARALLEL PROCESSING
This draft has been developed within the International Organization for Standardization (ISO), and
processed under the ISO-lead mode of collaboration
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27