|
PREDSTANDARD
maj 2005
Toplotnoizolacijski proizvodi za stavbe – Razsuti celulozni proizvodi za
oblikovanje na mestu vgradnje – 1. del: Specifikacija za proizvode pred
vgradnjo
Thermal insulation products for buildings - In-situ formed loose-fill cellulose
products - Part 1: Specification for the products before installation
ICS 91.120.10 Referenčna številka
oSIST prEN 15101-1:2005(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
prEN 15101-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS
English version
Thermal insulation products for buildings - In-situ formed loose-
fill cellulose products - Part 1: Specification for the products
before installation
Produits d'isolation thermique pour les bâtiments - Produits Wärmedämmstoffe für das Bauwesen - An der
isolants cellulosiques en vrac mis en forme sur place - Anwendungsstelle hergestelte Wärmedämmung aus
Partie 1 : Spécification des produits avant la mise en place Zellulosefasern (LFCI) - Teil 1: Spezifikation für die
Produkte vor dem Einbau
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 88.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 15101-1:2005: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
prEN 15101-1:2005 (E)
Contents Page
Foreword. 4
1 Scope. 5
2 Normative references . 5
3 Definitions, symbols and abbreviations. 6
4 Requirements . 8
5 Test methods. 11
6 Designation code . 13
7 Evaluation of conformity. 13
8 Marking and labelling . 14
Annex A (normative) Determination of declared thermal resistance and thermal
conductivity . 16
A.1 Input data . 16
A.2 Declared values. 16
Annex B (normative) Laboratory methods for the determination of settlement . 18
B.1 Introduction .
...