|
PREDSTANDARD
maj 2005
Toplotnoizolacijski proizvodi za stavbe – Razsuti celulozni proizvodi za
oblikovanje na mestu vgradnje – 2. del: Specifikacija za vgrajene proizvode
Thermal insulation products for buildings - In-situ formed loose-fill cellulose
products - Part 2: Specification for the installed products
ICS 91.120.10 Referenčna številka
oSIST prEN 15101-2:2005(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
prEN 15101-2
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS
English version
Thermal insulation products for buildings - In-situ formed loose-
fill cellulose products - Part 2: Specification for the installed
products
Produits isolant thermiques pour le bâtiment - Isolation en Wärmedämmstoffe für Gebäude - An der
vrac formée en place à base de cellulose - Partie 2: Anwendungsstelle hergestellte Wärmedämmung aus losem
Spécification des produits mis en place Zellulosefüllstoff - Teil 2: Spezifikation für die einbauten
Produkte
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 88.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 15101-2:2005: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
prEN 15101-2:2004 (E)
Contents Page
Foreword.3
1 Scope .4
2 Normative references .4
3 Definitions, symbols and abbreviations .4
4 Requirements.6
5 Test methods.7
6 Installers declaration.9
Annex A (normative) Cavity walls (floors) — Determination of average cavity width.10
A.1 Procedure .10
A.2 Calculation.10
A.3 Floors .10
Annex B (normative) Cavity walls and floors - Determination of installed density .11
B.1 Procedure .11
B.2 Calculation.11
Annex C (normative) Lofts — Determination of installed insulation thickness — Pin and plate
method .
...