|
oSIST prEN 16211:2011
01-marec-2011
3UH]UDþHYDQMHVWDYE0HULWYHSUHWRND]UDNDYVLVWHPXYHQWLODFLMH0HWRGH
Ventilation for buildings - Measurement of air flows on site - methods
Lüftung von Gebäuden - Luftvolumenstrommessung in Lüftungssystemen - Verfahren
Systèmes de ventilation pour les bâtiments - Mesurages de débit d'air dans les systèmes
de ventilation - Méthodes
Ta slovenski standard je istoveten z: prEN 16211
ICS:
91.140.30 3UH]UDþHYDOQLLQNOLPDWVNL Ventilation and air-
VLVWHPL conditioning
oSIST prEN 16211:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 16211:2011
---------------------- Page: 2 ----------------------
oSIST prEN 16211:2011
EUROPEAN STANDARD
DRAFT
prEN 16211
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2010
ICS 17.120.10; 91.140.30
English Version
Ventilation for buildings - Measurement of air flows on site -
methods
Systèmes de ventilation pour les bâtiments - Mesurages de Lüftung von Gebäuden - Luftvolumenstrommessung in
débit d'air dans les systèmes de ventilation - Méthodes Lüftungssystemen - Verfahren
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 156.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16211:2010: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 16211:2011
prEN 16211:2010 (E)
Contents Page
Introduction . 4
Foreword . 5
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 6
4 Symbols (and abbreviated terms) . 8
5 Preparation of measurement . 9
5.1 Factors influencing measurements. 9
5.2 Sources of errors and uncertainties . 10
5.2.1 Gross errors . 10
5.2.2 Systematic errors . 10
5.2.3 Calibration . 11
5.2.4 Uncertainties .
...