|
PREDSTANDARD
junij 2005
Geotehnično preiskovanje in preskušanje – Preskušanje geotehničnih
konstrukcij - 5. del: Preskušanje sider (ISO/DIS 22477-5:2005)
Geotechnical investigation and testing - Testing of geotechnical structures - Part 5:
Testing of anchorages (ISO/DIS 22477-5:2005)
ICS 93.020 Referenčna številka
oSIST prEN ISO 22477-5:2005(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
DRAFT
prEN ISO 22477-5
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2005
ICS
English version
Geotechnical investigation and testing - Testing of geotechnical
structures - Part 5: Testing of anchorages (ISO/DIS 22477-
5:2005)
Reconnaissance et essais géotechniques - Essais de
structures géotechniques - Partie 5: Essais d'ancrages
(ISO/DIS 22477-5:2005)
This draft European Standard is submitted to CEN members for parallel enquiry. It has been drawn up by the Technical Committee
CEN/TC 341.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN ISO 22477-5:2005: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
prEN ISO 22477-5:2005 (E)
Foreword
This document (prEN ISO 22477-5:2005) has been prepared by Technical Committee
CEN/TC 341 "Geotechnical Investigation and Testing", the secretariat of which is held by DIN,
in collaboration with Technical Committee ISO/TC 182 "Geotechnics".
This document is currently submitted to the parallel Enquiry.
2
---------------------- Page: 3 ----------------------
DRAFT INTERNATIONAL STANDARD ISO/DIS 22477-5
ISO/TC 182/SC 1 Secretariat: DIN
Voting begins on: Voting terminates on:
2005-04-21 2005-09-21
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Geotechnical investigation and testing — Testing of
geotechnical structures —
Part 5:
Testing of anchorages
Reconnaissance et essais géotechniques — Essais de structures géotechniques —
Partie 5: Essais d'ancrages
ICS 93.020
ISO/CEN PARALLEL ENQUIRY
This draft International Standard is a draft standard developed within the European Committee for
Standardization (CEN) and processed under the CEN-lead mode of collaboration as defined in the
Vienna Agreement. The document has been transmitted by CEN to ISO for circulation for ISO member
body voting in parallel with CEN enquiry. Comments received from ISO member bodies, including those
from non-CEN members, will be considered by the appropriate CEN technical body. Should this DIS be
accepted, a final draft, established on the basis of comments received, will be submitted to a parallel two-
month FDIS vote in ISO and formal vote in CEN.
In accordance with the provisions of Council Resolution 15/1993 this document is circulated in
the English language only.
Conformément aux dispositions de la Résolution du Conseil 15/1993, ce document est distribué
en version anglaise seulement.
To expedite distribution, this document is circulated as received from the committee secretariat.
ISO Central Secretariat work of editing and text composition will be undertaken at publication
stage.
Pour accélérer la distribution, le présent document est distribué tel qu'il est parvenu du
secrétariat du comité. Le travail de rédaction et de composition de texte sera effectué au
Secrétariat central de l'ISO au stade de publication.
THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE
REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL
...