|
oSIST prEN 16273:2011
01-julij-2011
Železniške naprave - Zgornji ustroj - Prekovane prehodne tirnice
Railway applications - Track - Forged rail transitions
Bahnanwendungen - Oberbau - Geschmiedete Schienenübergänge
Applications ferroviaires - Voie - Rails forgés
Ta slovenski standard je istoveten z: prEN 16273
ICS:
45.080 7UDþQLFHLQåHOH]QLãNLGHOL Rails and railway
components
oSIST prEN 16273:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 16273:2011
---------------------- Page: 2 ----------------------
oSIST prEN 16273:2011
EUROPEAN STANDARD
DRAFT
prEN 16273
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2011
ICS 93.100
English Version
Railway applications - Track - Forged rail transitions
Applications ferroviaires - Voie - Rails forgés Bahnanwendungen - Oberbau - Geschmiedete
Schienenübergänge
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 256.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16273:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 16273:2011
prEN 16273:2011 (E)
Contents Page
Foreword .3
Introduction .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .5
4 Information to be supplied for approval .7
4.1 By the purchaser.7
4.2 By the manufacturer .7
5 Approval of the manufacturer .7
6 Requirements for the forging process .7
6.1 General .7
6.2 Forging parameters .7
6.3 Post heat treatment .7
6.4 Profile finishing .
...