|
oSIST prEN 12209 rev:2011
01-junij-2011
6WDYEQRRNRYMH0HKDQVNHNOMXþDYQLFHLQSULMHPQLNL=DKWHYHLQSUHVNXVQH
PHWRGH
Building hardware - Mechanically operated locks and locking plates - Requirements and
test methods
Schlösser und Baubeschläge - Mechanisch betätigte Schlösser und Schließbleche -
Anforderungen und Prüfverfahren
Quincaillerie pour le bâtiment - Serrures mécaniques et gâches - Exigences et méthodes
d'essai
Ta slovenski standard je istoveten z: prEN 12209 rev
ICS:
91.190 Stavbna oprema Building accessories
oSIST prEN 12209 rev:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 12209 rev:2011
---------------------- Page: 2 ----------------------
oSIST prEN 12209 rev:2011
EUROPEAN STANDARD
DRAFT
prEN 12209 rev
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2011
ICS 91.190 Will supersede EN 12209:2003
English Version
Building hardware - Mechanically operated locks and locking
plates - Requirements and test methods
Quincaillerie pour le bâtiment - Serrures mécaniques et Schlösseer und Baubeschläge - Mechanisch betätigte
gâches - Exigences et méthodes d'essai Schlösser und Schließbleche - Anforderungen und
Prüfverfahren
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 33.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12209 rev:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 12209 rev:2011
prEN 12209:2011 (E)
Contents Page
Foreword . 5
Introduction . 6
1 Scope. 7
2 Normative references . 7
3 Terms, definitions, symbols and units . 7
3.1 Terms and definitions . 7
4 Classification . 11
4.1 General . 11
4.2 Classification for mechanically operated locks and locking plates . 11
4.2.3 Door mass and closing force (third digit). 12
4.2.4 Suitability for use on fire/smoke doors (fourth digit) . 13
4.2.6 Corrosion resistance and t
...