|
oSIST prEN 14037-4:2012
01-januar-2012
6WURSQHVHYDOQHSORãþH]DRJUHYDQMHLQKODMHQMHSRYUãLQ]DYRGRVWHPSHUDWXUR
SRGƒ&GHO3UHVNXVQHPHWRGH]PRJOMLYRVWLKODMHQMDVHYDOQLKVWURSQLKSORãþ
Free hanging heating and cooling surfaces for water with a temperature below 120°C -
Part 4: Test method for cooling capacity of ceiling mounted radiant panels
An der Decke frei abgehängte Heiz- und für Wasser mit einer Temperatur unter 120°C -
Teil 4: Prüfverfahren für die Kühlleistung von Deckenstrahlplatten
Panneaux rayonnants de plafond alimentés en eau à une température inférieure à 120°C
- Partie 4: Méthode d'essai de la capacité de refroidissement des panneaux rayonnants
de plafond
Ta slovenski standard je istoveten z: prEN 14037-4
ICS:
91.140.10 Sistemi centralnega Central heating systems
ogrevanja
91.140.60 Sistemi za oskrbo z vodo Water supply systems
oSIST prEN 14037-4:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 14037-4:2012
---------------------- Page: 2 ----------------------
oSIST prEN 14037-4:2012
EUROPEAN STANDARD
DRAFT
prEN 14037-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2011
ICS 91.140.30
English Version
Free hanging heating and cooling surfaces for water with a
temperature below 120 °C - Part 4: Test method for cooling
capacity of ceiling mounted radiant panels
Panneaux rayonnants de plafond alimentés en eau à une An der Decke frei abgehängte Heiz- und Kühlflächen für
température inférieure à 120 °C - Partie 4: Méthode d'essai Wasser mit einer Temperatur unter 120 °C - Teil 4:
de la capacité de refroidissement des panneaux rayonnants Prüfverfahren für die Kühlleistung von Deckenstrahlplatten
de plafond
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 130.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 14037-4:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 14037-4:2012
prEN 14037-4:2011 (E)
Contents
Foreword . 3
Introduction . 4
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Testing of cooling capacity . 5
4.1 Short description . 5
4.2 Test booth .
...