|
oSIST prEN ISO 14116:2011
01-junij-2011
9DURYDOQDREOHND=DãþLWDSUHGXþLQNLWRSORWHLQSODPHQD0DWHULDOLNRPELQDFLMH
PDWHULDORYLQREODþLOD]RPHMHQRVWRSQMRJRUOMLYRVWL ,62',6
Protective clothing - Protection against heat and flame - Limited flame spread materials,
material assemblies and clothing (ISO/DIS 14116:2011)
Schutzkleidung - Schutz gegen Hitze und Flammen - Materialien, Materialkombinationen
und Kleidung mit begrenzter Flammenausbreitung (ISO/DIS 14116:2011)
Vêtements de protection - Protection contre la chaleur et les flammes - Matériaux,
assemblages de matériaux et vêtements à propagation de flamme limitée (ISO/DIS
14116:2011)
Ta slovenski standard je istoveten z: prEN ISO 14116
ICS:
13.220.40 Sposobnost vžiga in Ignitability and burning
obnašanje materialov in behaviour of materials and
proizvodov pri gorenju products
13.340.10 Varovalna obleka Protective clothing
oSIST prEN ISO 14116:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN ISO 14116:2011
---------------------- Page: 2 ----------------------
oSIST prEN ISO 14116:2011
EUROPEAN STANDARD
DRAFT
prEN ISO 14116
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2011
ICS 13.340.10 Will supersede EN ISO 14116:2008
English Version
Protective clothing - Protection against heat and flame - Limited
flame spread materials, material assemblies and clothing
(ISO/DIS 14116:2011)
Vêtements de protection - Protection contre la chaleur et Schutzkleidung - Schutz gegen Hitze und Flammen -
les flammes - Matériaux, assemblages de matériaux et Materialien, Materialkombinationen und Kleidung mit
vêtements à propagation de flamme limitée (ISO/DIS begrenzter Flammenausbreitung (ISO/DIS 14116:2011)
14116:2011)
This draft European Standard is submitted to CEN members for parallel enquiry. It has been drawn up by the Technical Committee
CEN/TC 162.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN ISO 14116:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN ISO 14116:2011
prEN ISO 14116:2011 (E)
Contents Page
Foreword .3
2
---------------------- Page: 4 ----------------------
oSIST prEN ISO 14116:2011
prEN ISO 14116:2011 (E)
Foreword
This document (prEN ISO 14116:2011) has been prepared by Technical Committee CEN/TC 162 “Protective
clothing including hand and arm protection and lifejackets” the secretariat of which is held by DIN, in
collaboration with Technical Committee ISO/TC 94 "Personal safety - Protective clothing and equipment".
This document is currently submitted to the parallel Enquiry.
This document will supersede EN ISO 14116:2008.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
3
---------------------- Page: 5 ----------------------
oSIST prEN ISO 14116:2011
---------------------- Page: 6 ----------------------
oSIST prEN ISO 14116:2011
DRAFT INTERNATIONAL STANDARD ISO/DIS 14116
ISO/TC 94/SC 13 Secretariat: SNV
Voting begins on Voting terminates on
2011-03-24 2011-08-24
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Protective clothing — Protection against heat and flame —
Limited flame spread materials, material assemblies and
clothing
Vêtements de protection — Protection contre la chaleur et les flammes — Matériaux, assemblages de
matériaux et vêtements à propagation de flamme limitée
[Revision of first edition (ISO 14116:2008) and ISO 14116:2008/Cor.1:2009]
ICS 13.340.10
ISO/CEN PARALLEL PROCESSING
This draft has been developed within the European Committee for Standardization (CEN), and
processed under the CEN-lead mode of collaboration as defined in the Vienna Agreement.
This draft is hereby submitted to the ISO member bodies and to the CEN member bodies for a parallel
five-month enquiry.
Should this draft be accepted, a final draft, established on the basis of comments received, will be
submitted to a parallel two-month approval vote in ISO and formal vote in CEN.
In accordance with the provisions of Council Resolution 15/1993 this document is circulated in
the English language only.
Conformément aux dispositions de la Résolution du Conseil 15/1993, ce document est distribué
en version anglaise seulement.
To expedite distribution, this document is circulated as received from the committee
secretariat. ISO Central Secretariat work of editing and text composition will be undertaken at
publication stage.
Pour accélérer la distribution, le présent document est distribué tel qu'il est parvenu du
secrétariat du comité. Le travail de rédaction et de composition de texte sera effectué au
Secrétariat central de l'ISO au stade de publication.
THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE
REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME
STANDARDS TO WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS.
RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION.
© International Organization for Standardization, 2011
---------------------- Page: 7 ----------------------
oSIST prEN ISO 14116:2011
ISO/DIS 14116
Copyright notice
This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted
under the applicable laws of the user’s country, neither this ISO draft nor any extract from it may be
reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic,
photocopying, recording or otherwise, without prior written permission being secured.
Requests for permission to reproduce should be addressed to either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [email protected]
Web www.iso.org
Reproduction may be subject to royalty payments or a licensing agreement.
Violators may be prosecuted.
ii © ISO 2011 – All rights reserved
---------------------- Page: 8 ----------------------
oSIST prEN ISO 14116:2011
ISO/DIS 14116
Contents Page
Foreword .iv
1 Scope.1
2 Normative references.1
3 Terms and definitions .2
4 Clothing design.3
5 Sampling, pretreatment and ageing .3
5.1 Sampling.3
5.2 Pretreatment of Material .3
5.2.1 Pre-treatment by Cleaning.3
5.2.2 Ageing.4
5.2.3 Cleaning index.4
5.2.4 Final Index.4
6 Performance requirements.4
6.1 Thermal performance.4
6.2 Mechanical performance.5
6.3 Dimensional change of textile materials.5
7 Classification.6
7.1 Requirements for limited flame spread index 1 .6
7.2 Requirements for limited flame spread index 2 .6
7.3 Requirements for limited flame spread index 3 .6
8 Marking.7
8.1 Single-layer materials.7
8.2 Material assemblies.7
8.3 Garments.7
9 Information supplied by the manufacturer .8
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 89/686/EEC .9
Bibliography.10
© ISO 2010 – All rights reserved iii
DRAFT 2011
---------------------- Page: 9 ----------------------
oSIST prEN ISO 14116:2011
ISO/DIS 14116
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 14116 was prepared by Technical Committee ISO/TC 94, Personal safety -- Protective clothing and
equipment, Subcommittee SC 13, Protective clothing.
ISO 14116:XXXX supersedes ISO 14116:2008, which has been technically revised to include:
a) include test procedure for dry-cleaning in normative references;
b) include test procedure for non-woven materials in normative references;
c) modify clause in design requirements regarding garment overlaps;
d) modify pretreatment clause to include requirements for single use garments;
e) modify clause for ageing due to washing (maximum number of cleaning procedures as indicated by the
manufacturer);
f) include requirement for dimensional stabilty, including procedure when measuring dimensional stability;
g) modify pretreatment clause to specify that dimensional stability is carried out after five cleaning cycles;
h) modify test procedure for the flame testing of Labels, badges, retro-reflective materials;
i) include requirement and test procedure for burst strength testing of knitted materials;
j) include requirement and test procedure for tensile strength testing of non-woven materials;
k) include requirement and test procedure for tear strength testing of non-woven materials;
l) include requirement and test procedure for burst strength testing of non-woven materials;
m) modify requirement for tear strength of woven materials;
n) modify afterglow requirement for flame spread of Index 3 materials.
o) include statement for flame spread testing in regard to interlining materials for Index 2 and 3 materials;
iv © ISO 2010 – All rights reserved
DRAFT 2011
---------------------- Page: 10 ----------------------
oSIST prEN ISO 14116:2011
DRAFT INTERNATIONAL STANDARD prEN ISO/DIS 14116
Protective clothing — Protection against heat and flame —
Limited flame spread materials, material assemblies and
clothing
1 Scope
This International Standard specifies the performance requirements for the limited flame spread properties of
materials, material assemblies and protective clothing in order to reduce the possibility of the clothing burning
and thereby itself constituting a hazard. Additional requirements for clothing are also specified.
Protective clothing complying with this International Standard is intended to protect workers against
occasional and brief contact with small igniting flames, in circumstances where there is no significant heat
hazard and without the presence of another type of heat. When protection against heat hazards is necessary
in addition to protection against limited spread flammability, then standards, such as ISO 11612, are more
appropriate.
A classification system is given for materials, material assemblies and garments which are tested according to
ISO 15025:2000, Procedure A.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 13934-1:1999, Textiles — Tensile properties of fabrics — Part 1: Determination of maximum force and
elongation at maximum force using the strip method
ISO 13935-2:1999, Textiles — Seam tensile properties of fabrics and made-up textile articles — Part 2:
Determination of maximum force to seam rupture using the grab method
ISO 13937-2:2000, Textiles — Tear properties of fabrics — Part 2: Determination of tear force of trouser-
shaped test specimens (Single tear method)
ISO 13938-1, Textiles — Bursting properties of fabrics — Part 1: Hydraulic method for determination of
bursting strength and bursting distension
ISO 15025:2000, Protective clothing — Protection against heat and flame — Method of test for limited flame
spread
EN 13688, Protective clothing — General requirements
ISO 9073-4, Textiles — Test Methods for non wovens — Part 4; Determination of tear resistance
ISO 3175-2 : 1998, Textiles — Dry Cleaning and finishing — Part 2 Procedures
...