prEN 16612

Glass in building - Determination of the load resistance of glass panes by calculation and testing

prEN 16612

Name:prEN 16612   Standard name:Glass in building - Determination of the load resistance of glass panes by calculation and testing
Standard number:prEN 16612   language:English language
Release Date:15-Mar-2015   technical committee:CEN/TC 129 - Glass in building
Drafting committee:CEN/TC 129/WG 8 - Mechanical strength   ICS number:81.040.20 - Glass in building
SLOVENSKI STANDARD
oSIST prEN 16612:2013
01-september-2013
6WHNORYJUDGEHQLãWYX8JRWDYOMDQMHRGSRUQRVWLVWHNOHQLKSORãþSURWLREUHPHQLWYL
]L]UDþXQRPLQSUHVNXãDQMHP
Glass in building - Determination of the load resistance of glass panes by calculation and
testing
Glas im Bauwesen - Bestimmung des Belastungswiderstandes von Glasscheiben durch
Berechnung und Prüfung
Verre dans la construction - Détermination de la résistance des feuilles de verre par
calcul et par essai
Ta slovenski standard je istoveten z: prEN 16612
ICS:
81.040.20 Steklo v gradbeništvu Glass in building
oSIST prEN 16612:2013 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 16612:2013

---------------------- Page: 2 ----------------------
oSIST prEN 16612:2013


EUROPEAN STANDARD
DRAFT
prEN 16612
NORME EUROPÉENNE

EUROPÄISCHE NORM

May 2013
ICS 81.040.20
English Version
Glass in building - Determination of the load resistance of glass
panes by calculation and testing
Verre dans la construction - Détermination de la résistance Glas im Bauwesen - Bestimmung des
des feuilles de verre par calcul et par essai Belastungswiderstandes von Glasscheiben durch
Berechnung und Prüfung
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 129.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16612:2013: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 16612:2013
prEN 16612:2013 (E)
Contents Page
Foreword .4
Introduction .5
1 Scope .6
2 Normative references .6
3 Terms and definitions .7
4 Symbols and abbreviations .9
5 Requirements . 14
5.1 Basis of determination of load resistance of glass . 14
5.2 General requirements . 15
5.3 Material partial factor . 15
5.4 Process of determining the load resistance of glass . 15
6 Mechanical and physical properties of glass .
...

  • Relates Information
  • ISO 8130-9:1992

    ISO 8130-9:1992 - Coating powders
    09-28
  • EN 352-2:2020/FprA1

    EN 352-2:2021/oprA1:2023
    09-28
  • IEC TS 61158-4:1999

    IEC TS 61158-4:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 4: Data Link protocol specification Released:3/24/1999 Isbn:2831847656
    09-28
  • HD 566 S1:1990

    HD 566 S1:1998
    09-28
  • ISO 5131:1982/Amd 1:1992

    ISO 5131:1982/Amd 1:1992
    09-28
  • EN 60598-2-22:1990

    EN 60598-2-22:1996
    09-27
  • ISO 8504-2:1992

    ISO 8504-2:1992 - Preparation of steel substrates before application of paints and related products -- Surface preparation methods
    09-27
  • EN 12165:2024

    prEN 12165:2022
    09-27
  • IEC TS 61158-6:1999

    IEC TS 61158-6:1999 - Digital data communications for measurement and control - Fieldbus for use in industrial control systems - Part 6: Application Layer protocol specification Released:3/24/1999 Isbn:2831847613
    09-27
  • ISO 4252:1992

    ISO 4252:1992 - Agricultural tractors -- Operator's workplace, access and exit -- Dimensions
    09-27