|
oSIST prEN 16613:2013
01-september-2013
Steklo v gradbeništvu - Lepljeno steklo in lepljeno varnostno steklo - Ugotavljanje
mehanskih lastnosti vmesnih slojev
Glass in building - Laminated glass and laminated safety glass - Determination of
interlayer mechanical properties
Glas im Bauwesen - Verbundglas und Verbundsicherheitsglas - Bestimmung der
mechanischen Eigenschaften von Zwischenschichten
Ta slovenski standard je istoveten z: prEN 16613
ICS:
81.040.20 Steklo v gradbeništvu Glass in building
oSIST prEN 16613:2013 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 16613:2013
---------------------- Page: 2 ----------------------
oSIST prEN 16613:2013
EUROPEAN STANDARD
DRAFT
prEN 16613
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2013
ICS 81.040.20
English Version
Glass in building - Laminated glass and laminated safety glass -
Determination of interlayer mechanical properties
Glas im Bauwesen - Verbundglas und
Verbundsicherheitsglas - Bestimmung der mechanischen
Eigenschaften von Zwischenschichten
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 129.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 16613:2013: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 16613:2013
prEN 16613:2013 (E)
Contents Page
Foreword .3
Introduction .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .5
4 Symbols and abbreviations .6
5 Selection of testing procedure .7
5.1 Isotropic interlayer materials .7
5.2 Non-isotropic interlayer materials .7
5.3 Interlayers which cannot be formed into small test pieces .8
6 Test procedure .8
6.1 General .8
6.2 Test specimens .
...