|
oSIST prEN 3-8:2014
01-februar-2014
3UHQRVQLJDVLOQLNLGHO'RGDWQH]DKWHYHN(1]DNRQVWUXNFLMRWODþQD
RGSRUQRVWLQPHKDQVNLSUHVNXVL]DJDVLOQLNH]QDMYHþMLPGRYROMHQLPWODNRP
HQDNLPDOLQLåMLPRGEDUYVNODGX]]DKWHYDPLVWDQGDUGD(1
Portable fire extinguishers - Part 8: Requirements for the construction, pressure
resistance and mechanical tests for extinguishers with a maximum allowable pressure
equal to or lower than 30 bar, which comply with the requirements of EN 3-7
Tragbare Feuerlöscher - Teil 8: Anforderungen an die konstruktive Ausführung,
Druckfestigkeit und mechanischen Prüfungen für tragbare Feuerlöscher mit einem
Höchstdruck kleiner gleich 30 bar, welche die Anforderungen aus EN 3-7 erfüllen
Extincteurs d'incendie portatifs - Partie 8: Exigences pour la construction, la résistance à
la pression et les essais mécaniques pour les extincteurs conformes à l'EN 3-7 dont la
pression maximale admissible est inférieure ou égale à 30 bar
Ta slovenski standard je istoveten z: prEN 3-8
ICS:
13.220.10 Gašenje požara Fire-fighting
oSIST prEN 3-8:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 3-8:2014
---------------------- Page: 2 ----------------------
oSIST prEN 3-8:2014
EUROPEAN STANDARD
DRAFT
prEN 3-8
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2013
ICS 13.220.20 Will supersede EN 3-8:2006
English Version
Portable fire extinguishers - Part 8: Requirements for the
construction, pressure resistance and mechanical tests for
extinguishers with a maximum allowable pressure equal to or
lower than 30 bar, which comply with the requirements of EN 3-7
Extincteurs d'incendie portatifs - Partie 8: Exigences pour la Tragbare Feuerlöscher - Teil 8: Anforderungen an die
construction, la résistance à la pression et les essais konstruktive Ausführung, Druckfestigkeit und mechanischen
mécaniques pour les extincteurs conformes à l'EN 3-7 dont Prüfungen für tragbare Feuerlöscher mit einem
la pression maximale admissible est inférieure ou égale à Höchstdruck kleiner gleich 30 bar, welche die
30 bar Anforderungen aus EN 3-7 erfüllen
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 70.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 3-8:2013 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 3-8:2014
prEN 3-8:2013 (E)
Contents
Page
Foreword .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .5
4 Symbols and abbreviations .7
5 Materials .
...