|
SLOVENSKI STANDARD
01-julij-2022
Snežne freze - Varnostne zahteve in preskusni postopki - 3. del: Snežne freze, na
katerih se sedi - Dopolnilo A1 (ISO 8437-3:2019/DAM 1:2022)
Snow throwers - Safety requirements and test procedures - Part 3: Ride-on snow
throwers - Amendment 1 (ISO 8437-3:2019/DAM 1:2022)
Chasse-neige - Exigences de sécurité et essais - Partie 3: Chasse-neige à conducteur
porté - Amendement 1 (ISO 8437-3:2019/DAM 1:2022)
Ta slovenski standard je istoveten z: EN ISO 8437-3:2021/prA1
ICS:
43.160 Vozila za posebne namene Special purpose vehicles
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT AMENDMENT
ISO 8437-3:2019/DAM 1
ISO/TC 23/SC 13 Secretariat: ANSI
Voting begins on: Voting terminates on:
2022-05-19 2022-08-11
Snow throwers — Safety requirements and test
procedures —
Part 3:
Ride-on snow throwers
AMENDMENT 1
Chasse-neige — Exigences de sécurité et essais —
Partie 3: Chasse-neige à conducteur porté
AMENDEMENT 1
ICS: 43.160
This document is circulated as received from the committee secretariat.
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
ISO/CEN PARALLEL PROCESSING
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO 8437-3:2019/DAM 1:2022(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION. © ISO 2022
ISO 8437-3:2019/DAM 1:2022(E)
© ISO 2022
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
ii
ISO 8437-3:2019/DAM 1:2022(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the wor
...