I will only use solar generators and hydroelectric generators.
1. Solar generators, as the name suggests, can only generate electricity in places with sunlight, and of course not at night. Place it on the ground first and connect it with fiberglass wires, as shown in the picture.
Then connect the power storage box, as shown in the figure.
The speed on the left has a smaller capacity; the speed in the middle is faster and has a larger capacity; the speed on the right has a larger capacity.
2. Hydroelectric generators, as the name suggests, can only generate electricity in water. They are placed in the water and connected with fiberglass wires. As shown in the picture.
Hold down shift before connecting, otherwise it will open. Then connect the power storage box, as shown in the figure.
At this time, the speed is unified and the capacity is as above.
That’s it, put the dead equipment into the power storage box and it can be charged.
Preparation:
1. Check whether the antifreeze in the generator water tank, diesel oil in the oil barrel, and generator oil are missing.
2. Check whether the generator battery switch is closed, whether the gear switch is in the low speed position, whether the power supply switch behind the generator is closed, and whether the power supply switch of the power generation room transformer is closed.
3. During a power outage, convert the internal and external lines of the main transformer to generate electricity:
1. Turn on the generator battery switch.
2. Turn the generator start button to start the generator. After the generator starts normally, adjust the low speed gear to the high speed gear and pay attention to whether the generator voltage is at 380 volts.
3. When the voltage stabilizes at 380 volts, turn on the generator and then turn on the power switch.
Fourth, after completing the above three steps, turn the power supply switch of the transformer in the power generation room to complete the power supply to the west hospital area.