In this case, the usr125 belt can be removed.
There is no wind cannon to remove the usr125 belt. Removing the USR125 belt requires a few specific tools, including an 8-inch socket, a 10-inch socket, a 17-inch socket, and a pulley brake tool. Use these tools to open the belt box and remove the front pulley from the scooter.
Even without a wind cannon, the usr125 belt can still be removed as long as you use the correct tools.
How to remove the 125 motorcycle pulley screw without an air cannon
ScooterThe rear wheel nut cannot be removed with an electric air cannon. No need If you are in a hurry, you can use bolt loosening agent; you can also lubricate with engine oil, tap with a hammer, wait ten minutes and then lubricate and tap again. Some screws need to be lubricated and soaked in engine oil for a whole day before they can be removed.
Whether there is a gasket inside the rear axle screw of a scooter depends on the specific situation. Some screws have their own pads, so there is no need to install a spacer, but some screws do not have a spacer, so there will be a spacer. You will know what kind of screw the rear axle is. .
When it is tight, it is a straight thread, when it is loose, it is a reverse thread, so the pulley screw is a straight thread. Here is a simple and practical method for you. The two nuts are straight threads. If the nuts are screwed, use a chopper to chop the nuts. Because it is genuine wire, use two new nuts when installing. It is best to use an air cannon to move in the future, which saves time and effort. If you buy it, don’t buy a cheap one because it is not strong enough. It costs about 400-500 yuan, a magneto clip and an impact driver. It's not very easy to use.
Use a 17# socket wrench to remove each screw in the counterclockwise direction. If it cannot be tightened, you can put a longer booster rod on the sleeve. Do not tighten the socket in the opposite direction. It is best to use hexagonal ones, not plum ones.
What does it mean to step up and stay still. If it was originally too tight, the wrench you used is not good enough. Wheel screws generally require a relatively large tightening torque and are best removed with a sleeve or eye wrench.
For the front pulley screw of the 125 scooter, if there is no wind cannon, you can fix the magneto rotor with tools such as magneto clamps, or directly fix the front pulley screw with a tool. To disassemble the pulley from the periphery, you can also use a hammer + flat shovel to drive out the screws, but try not to do this. The rear pulley can be directly fixed on the housing with magneto clips, and then removed with a socket wrench. Of course, you can also use a hammer + flat shovel to drive out the screws.