1. First, pull out the ring rope near the end of the tent's wind rope slider, as shown in the picture below:
2. Then use it to cover the ground nails, as shown in the picture below. Display:
3. Then select the position of the ground nails according to the ground conditions. Generally speaking, the smaller the angle between the windproof rope and the ground, the better the wind resistance of the tent. Place the ground nails at an angle of 45-60 degrees. Insert it into the ground so that the force is greatest, as shown in the figure below:
4. Then adjust the tightness of the wind rope, as shown in the figure below:
5. Release your hands. If the entire tent rope is still very tight, it means that the windproof rope is set up, as shown in the figure below:
The difference between paracord and wind rope
Wind How to use the rope buckle:
When using it, insert the non-sliding end of the windproof rope into the buttonhole of the tent, tie it tightly, and then start to adjust the sliding end of the windproof rope so that the sliding piece can be aligned with the wind. The rope buckle is fixed.
1. Step 1: Pull out the ring rope near the end of the rope in the sliding piece and cover the ground nails. No matter what kind of tent peg you use, use it to tighten it.
2. Step 2: Select the location of the ground nails according to the ground conditions. Generally speaking, the smaller the angle between the windproof rope and the ground, the better the wind resistance of the tent. Insert the ground nails into the ground at an angle of 45-60 degrees to maximize the stress.
3. Step 3: Tighten the front end of the windproof rope with one hand, hold the three-hole slide with the other hand and push it closer to the tent end. Tighten firmly, the tighter the better.
4. Step 4: Release your hands. If the entire tent rope is still very tight, it means that the windproof rope is set up. If you find any looseness, just follow the above method and continue to tighten it.
Follow the above four steps to use the wind rope buckle correctly. The main purpose of the wind rope buckle is to properly isolate the inside and outside of the tent. Only when it is done well can the wind rope buckle play its role.
How to add wind rope to Lengshan 3
The differences between paracord and wind rope are:
1. Different quality: wind ropes are mostly made of nylon, which is thicker A little more solid. Parachute rope is thin, soft, high-strength, has a high elastic modulus and is smaller than the breaking elongation of the parachute fabric.
2. Different uses: Wind ropes are suitable for tents or mountain tents with high wind protection requirements, canopy ropes, and strapping ropes. Paracord is the skeleton of the parachute and is mainly used to secure the tent.
1. First, to add wind rope to Cold Mountain 3, you need to find the three-hole cutout of the windproof rope, insert the non-slip end of the windproof rope into the buttonhole of the tent, and tie it tightly.
2. Secondly, start to adjust one end of the slider, and then pull out the ring rope near the end of the slider to cover the ground nails.
3. Finally, tighten the front end of the windproof rope with one hand, hold the three-hole slide with the other hand and push it closer to the tent end, tighten it with force, the tighter the better, Cold Mountain 3 is enough Add wind rope.