1. The motor makes a whistling sound, which sounds like steam or air coming out of the motor. Typically, after hearing this sound, the engine will quickly lose power. Possible problem, engine overheats, check cooling system. The exhaust system is clogged, the suction pipe is leaking or broken.
2. When I stepped on the accelerator, I found that the acceleration was not obvious, there was a lack of power, and the engine made a hysterical noise. The times most likely to occur are when the engine is hot or cold, or when it is low on oil. The causes of these problems can be divided into air filter, spark plug, ignition wire, gasoline, fuel filter, carburetor, oil pump and other problems. Check if the air filter is dirty, if the spark plug is old and needs to be replaced, if the ignition coil is broken and if the gasoline is not clean, such aswater in the oil line. Also check the oil pump.
3. A very loud noise comes from the exhaust, which is very annoying. Sometimes a similar noise comes from the front. The main problem is the exhaust system. Check if the exhaust pipe is broken.
4. The motor makes a kicking sound, like the sound of a pencil hitting the table. The sound increases as engine speed increases. The possible cause is that there is dirt inside the engine. It is recommended to change the oil, filter and clean the engine. Others may be a valve problem.
5. When driving, acceleration is normal and ignition may be normal. However, if you drive at a constant speed, you notice that the engine speed is too high but the speed still seems to be. unable to increase. Try checking the coolant. Oil pressure is too high or toolow. Check the pressure gauge. There may be a problem with the ignition time setting, which may also cause such symptoms. As with others, it could be a problem internal to the engine, such as a clogged EGR valve.
6. When the motor is running, it makes a clicking sound, as if something is hitting metal. When accelerating or driving, you may not hear anything. This may be caused by the cylinder valve, which can be changed by adjusting the valve. Lack of engine oil can also cause similar problems. Additionally, engine oil pressure is relatively low.
7. When accelerating, the engine will make a whirring sound, or it will also sound when decelerating. In short, the sound will change as the regime changes. Possible reason is lack of power steering oil, fill it up. The generator bearings could be damaged. Problems with the pomThe power steering and water pump will produce similar noises.
8. When you press the gas pedal, you will hear a clicking noise coming from the exhaust pipe. The sound may not be very loud and the car will not drive abnormally, as well as fuel consumption. will increase. It is recommended to check the muffler and exhaust pipe for damage.
Refeng S2 generator belt installation method
JAC Refeng S2, Belgian Punch CVT gearbox, made in Nanjing. This model has been used in China for five or six years and is used by many domestic models (such as Geely Emgrand 718). The sales volume is large, the stability is good, and there is no negative news yet. Overall, good value for money. The engine number usually contains information such as engine model, production time and original code.ne, and constitutes important archival information for the vehicle. Each engine has a unique engine number, making it easier for engine manufacturers and vehicle management services to manage vehicle engines. The JACS2 engine number is usually found on the cylinder block. Pay special attention to changing the engine number when repairing or replacing the engine. If you want to buy a used car, you should also check whether the engine number is complete and consistent, so as not to cause unnecessary trouble when carrying out the relevant procedures for the vehicle. If there is no engine number on the engine block, you can check the engine connection to the transmission or get closer to the generator.
1. First loosen the generator fixing screw and the belt tightness adjustment screw.
2. Second, place the Ruifeng 2 generator againstthe engine so that the distance between the pulleys is the shortest, then place the belt cover on the rocker hammer.
3. Finally, adjust the belt tightness to the appropriate level, tighten the motor mounting screws and adjust the screws.