1. During long-term use of the generator, the enameled wire will age due to high internal temperature and vibration (insulation performance decreases)
Solution: Replace the enameled wire.
2. Due to bearing play, friction between the stator and rotor of the generator causes an internal short circuit.
Solution: Repair the generator bearings.
Detailed information:
Notes
① Frequent cleaning remove dirt and dust outside the generator, keep it clean and well ventilated.
② Frequently check the tightening conditions of the generator-related fasteners and tighten the screws in time.
③The tension of the transmission belt must be appropriate. If it is too loose, it will slip easily and result in insufficient power production; if it is too tight, it will easily damage the belt bearings and du generator.
④When installing the battery, be careful not to install it incorrectly. Usually, install the positive wire first and not the ground wire, otherwise the diode will burn out easily.
⑤ When using an integrated circuit regulator, the ignition switch should be turned off immediately when the engine is not running.
⑥ It is never allowed to use the “scraping” method to test whether to produce electricity.
⑦ When the generator fails to generate electricity, it must be eliminated in time, otherwise it will cause more serious failure.