Thin film photovoltaic bus kit instructions for use should be installed and used according to the instructions. After the photovoltaic lightning protection combiner box is connected to the photovoltaic power generation system according to the installation principle and wiring diagram, the ground terminal of the lightning protection box should be connected from reliably to the ground wire or bus bar of the lightning protection. as short and straight as possible, and the connecting wire should be The cross section is not less than 16 mm2 stranded copper core. The grounding resistance value should not be greater than 4 ohms. Otherwise, the ground network must be rectified to ensure the lightning protection effect. It can only be put into service once the installation has been completed and verified.
How to use thin film photovoltaic bus kit
Introduction How to Use Thin Film Photovoltaic Bus Kit How to Use Thin Film Photovoltaic Bus Kit Install and use it according to the instructions. Connect the photovoltaic lightning protection combiner box to the photovoltaic power generation system according to the i