1. Advantages:
1. Fast adsorption speed: Gas adsorption generally reaches adsorption equilibrium within tens of seconds to minutes, which is 2 to 3 orders of magnitude higher than GAC.
2. Good temperature resistance: It can withstand high temperatures above 1000°C in inert gas and has a flash point of 500°C in air. It can guarantee a lifespan of 30,000 hours at a continuous high temperature of 300°C.
3. Acid and alkali resistant, with good electrical conductivity and chemical stability.
2. Disadvantages:
1. Compared to heating methods such as underfloor heating, the installation cost is higher and a special floor for underfloor heating must be laid. the room should be 2 to 4 cm higher than the cement floor. Rooms with a floor height of less than 2.5 m will be oppressive.
2. The cost of installationlation in bathrooms, kitchens and other places prone to blistering is relatively high, and solid wood floors cannot be used. Instead, composite wood floors, ceramic tiles, and marble floors can be used. used.
Detailed information:
Carbon fiber electric floor heating is made of a large number of microscopic carbon crystals which can rub and oscillate with each other under the action of an electric field. The crystals undergo “Brownian motion” under the action of the electric field. the action of the electric field and generate a large amount of heat. A large amount of experimental data confirms that the electrical to heat conversion efficiency of carbon fiber crystals reaches more than 98%, which is more than 20% phigher than that of commonly used electric heating wires such as nickel-chromium alloys. carbon fiber electric floor heating systems.
When the indoor wind speed is less than 0.05 ms, a 1°C change in the average radiation temperature has basically the same impact on the thermal sensation of the human body as the average temperature of the far infrared radiation produced by far infrared radiation. Carbon gasket electric underfloor heating is taller and extends along the inside edge. The temperature distribution is uniform in the height direction and the temperature gradient is small. People are in the heating zone and the highest heating temperature zone of the radiator is located on the. wall, using the principle of convection heating.
The temperature gradient is important. When people feel the same temperature, theAverage indoor air temperature in the room heated by carbon fiber electric floor heating is lower than the porcelain air temperature in the room heated by convection. , reducing the thermal load of the room. Under equivalent thermal comfort conditions, the calculated indoor temperature of carbon fiber electric floor heating and radiant heating can be 2-3°C lower than traditional convection radiator heating systems.
Baidu Encyclopedia - Carbon fiber floor heating
Baidu Encyclopedia - Floor heating
For wood floor heating, when you sleep at night, open the fireplace and don't get up. Add firewood. Shake off the ashes burning in the boiler to the bottom third as much as possible, add new coal to the upper two thirds, add coal slime and a little water, and stick it to the insidetersection as if you are mixing cement. in the middle and open the hole. Don't make it too big. Close all boiler oven doors. Turn the fireplace switch halfway off and don't open it all the way. Turn the heat to cooking position. and do not use the heating position. When you wake up in the morning, open the vent under the oven and set the heat to the heat setting. The fireplace is completely open.