|
SIST ISO 4384-2:2015
01-marec-2015
1DGRPHãþD
SIST ISO 4384-2:2002
Drsni ležaji - Preskušanje trdote materialov za ležaje - 2. del: Trdi materiali
Plain bearings - Hardness testing of bearing metals - Part 2: Solid materials
Paliers lisses - Essai de dureté des matériaux antifriction - Partie 2: Matériaux massifs
Ta slovenski standard je istoveten z: ISO 4384-2:2011
ICS:
21.100.10 Drsni ležaji Plain bearings
SIST ISO 4384-2:2015 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 4384-2:2015
---------------------- Page: 2 ----------------------
SIST ISO 4384-2:2015
INTERNATIONAL ISO
STANDARD 4384-2
Second edition
2011-05-01
Plain bearings — Hardness testing of
bearing metals —
Part 2:
Solid materials
Paliers lisses — Essai de dureté des matériaux antifriction —
Partie 2: Matériaux massifs
Reference number
ISO 4384-2:2011(E)
©
ISO 2011
---------------------- Page: 3 ----------------------
SIST ISO 4384-2:2015
ISO 4384-2:2011(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2011
or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [email protected]
Web www.iso.org
Published in Switzerland
ii © ISO 2011 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 4384-2:2015
ISO 4384-2:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 4384-2 was prepared by Technical Committee ISO/TC 123, Plain bearings, Subcommittee SC 2,
Materials and lubricants, their properti
...