|
Standard
ISO/ASTM 52933
First edition
Additive manufacturing —
2024-03
Environment, health and safety
— Test method for the hazardous
substances emitted from material
extrusion type 3D printers in the
non-industrial places
Fabrication additive — Environnement, santé et sécurité —
Méthode d'essai pour les substances dangereuses émises par les
imprimantes 3D de type à extrusion de matière dans les lieux non
industriels
Reference number
ISO/ASTM 52933:2024(en) © ISO/ASTM International 2024
---------------------- Page: 1 ----------------------
ISO/ASTM 52933:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO/ASTM International 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester. In the United States, such requests should be sent to ASTM International.
ISO copyright office ASTM International
CP 401 • Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700
CH-1214 Vernier, Geneva West Conshohocken, PA 19428-2959, USA
Phone: +41 22 749 01 11 Phone: +610 832 9634
Fax: +610 832 9635
Email: [email protected] Email: [email protected]
Website: www.iso.org Website: www.astm.org
Published in Switzerland
© ISO/ASTM International 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO/ASTM 52933:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Hazardous substance targets and major factors . 3
5 Relevant test standards. 3
6 Sampling conditions . 4
6.1 Sampling location .4
6.2 Sampling planning .4
7 Measurement methods . 6
7.1 Active and time-integrated methods .6
7.1.1 Purpose .6
7.1.2 VOCs analysis . . .6
7.1.3 Aldehyde method .9
7.2 Real-time method .
...