|
Standard
ISO 10882-1
Third edition
Health and safety in welding and
2024-04
allied processes — Sampling of
airborne particles and gases in the
operator's breathing zone —
Part 1:
Sampling of airborne particles
Hygiène et sécurité en soudage et techniques connexes —
Échantillonnage des particules en suspension et des gaz dans la
zone respiratoire des opérateurs —
Partie 1: Échantillonnage des particules en suspension
Reference number
ISO 10882-1:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO 10882-1:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO 10882-1:2024(en)
Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
3.1 General definitions.2
3.2 Sampling definitions.3
3.3 Welding terms .5
3.4 Statistical terms .6
4 Principle . 6
5 Requirement . 7
6 Equipment . 7
6.1 Sampling equipment .7
6.2 Weighing equipment, if required .8
7 Assessment strategy . 9
8 Measurement strategy . 9
8.1 General .
...