|
Specification
ISO/TS 8100-22
First edition
Lifts for the transport of persons
2024-06
and goods —
Part 22:
Prerequisites for certification of
lifts, model lifts, lift components
and lift functions
Ascenseurs pour le transport de personnes et d'objets —
Partie 22: Prérequis pour la certification des ascenseurs,
des ascenseurs modèles des composants et des fonctions des
ascenseurs
Reference number
ISO/TS 8100-22:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO/TS 8100-22:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: [email protected]
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO/TS 8100-22:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Prerequisites for certification of lifts, model lifts, lift components and lift functions . 3
4.1 Process .3
4.2 Description of the object of safety assessment .4
4.3 Implementing GESRs .4
4.4 Pre-requisite for certification .4
4.5 Risk assessment criteria for certification .4
4.6 Technical compliance documentation (TCD) .5
Annex A (informative) Marking . 7
Bibliography . 9
© ISO 2024 – All rights reserved
iii
---------------------- Page: 3 ----------------------
ISO/TS 8100-22:2024(en)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of e
...