|
TECHNICAL SPECIFICATION
Electronic Signatures and Infrastructures (ESI);
Certificate Profiles;
Part 1: Overview and common data structures
---------------------- Page: 1 ----------------------
2 ETSI TS 119 412-1 V1.0.1 (2015-07)
Reference
RTS/ESI-0019412-1-TS
Keywords
e-commerce, electronic signature, security,
trust services
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2015.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
3 ETSI TS 119 412-1 V1.0.1 (2015-07)
Contents
Intellectual Property Rights . 4
Foreword . 4
Modal verbs terminology . 4
Introduction . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 5
3 Definitions and abbreviations . 6
3.1 Definitions . 6
3.2 Abbreviations . 6
4 ETSI TS 119 412 certificate profiles . 6
4.1 General approach . 6
4.2 Overview of other parts of ETSI TS 119 412 . 7
4.2.1 ETSI TS 119 412-2 . 7
4.2.2 ETSI TS 119 412-3 . 7
4.2.3 ETSI TS 119 412-4 . 7
4.2.4 ETSI TS 119 412-5 . 7
5 Common data structures . 8
5.1 Semantics identifiers . 8
5.1.1 General . 8
5.1.2 ASN.1 module . 8
5.1.3 Natural person semantics identifier . 9
5.1.4 Legal person semantics identifier . 9
History . 11
ETSI
---------------------- Page: 3 ----------------------
4 ETSI TS 119 412-1 V1.0.1 (2015-07)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Electronic Signatures and
Infrastructures (ESI).
The present document is part 1 of a multi-part deliverable covering the Certificate Profiles, as identified below:
Part 1: "Overview and common data structures;
Part 2: "Certificate profile for certificates issued to natural persons";
Part 3: "Certificate profile for certificates issued to legal persons";
Part 4: "Certificate profile for web site certificates issued to organizations";
Part 5: "QCStatements".
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
ITU and ISO issued standards for certification of public keys in Recommendation ITU X.509 | ISO/IEC 9594-8 [i.3]
which are used for the security of communications and data for a wide range of electronic applications.
Regulation (EU) No 910/2014 [i.9] of the European Parliament and of the Council of 23 July 2014 on electronic
identification and trust services for electronic transactions in the internal market and repealing Directive 1999/93/EC
defines requirements on specific types of certificates named "qualified certificates". Implementation of Directive
1999/93/EC [i.1], superseded by the Regulation (EU) No 910/2014 [i.9], and deployment of certificate infrastructures
throughout Europe as well as in countries outside of Europe, have resulted in a variety of certificate implementations for
use in public and closed environments, where some are declared as qualified certificates while others are not.
Applications need support from standardized and interoperable identity certificates profiles, in particular when
applications are used for electronic signatures, authentication and secure electronic exchange in open environments and
international trust scenarios, but also when certificates are used in local application contexts.
This multi-part document aims to maximise the interoperability of systems issuing and using certificates both in the
European context under the Regulation (EU) No 910/2014 [i.9] and in the wider international environment.
ETSI
---------------------- Page: 4 ----------------------
5 ETSI TS 119 412-1 V1.0.1 (2015-07)
1 Scope
The present document provides an overview of the X.509 | ISO/IEC 9594-8 [i.3] based certificate profiles and the
statements for qualified certificates specified in other parts of ETSI TS 119 412 [i.4] to [i.7]. It specifies common data
structures that are referenced from other parts of ETSI TS 119 412 [i.4] to [i.7].
The profiles specified in this multi-part document aim to support both the Regulation (EU) No 910/2014 [i.9] and use of
certificates in a wider international context. Within the European context, it aims to support both EU Qualified
Certificates and other forms of certificate.
2 References
2.1 Normative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
The following referenced documents are necessary for the application of the present document.
[1] IETF RFC 3739: "Internet X.509 Public Key Infrastructure: Qualified Certificates Profile".
[2] ISO 3166: "Codes for the representation of names of countries and their subdivisions".
2.2 Informative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] Directive 1999/93/EC of the European Parliament and of the Council of 13 December 1999 on a
Community framework for electronic signatures.
[i.2] ETSI TS 119 401: "Electronic Signatures and Infrastructures (ESI); General Policy Requirements
for Trust Service Providers".
[i.3] Recommendation ITU-T X.509/ISO/IEC 9594-8: "Inf
...