|
TECHNICAL SPECIFICATION
Electronic Signatures and Infrastructures (ESI);
Associated Signature Containers (ASiC);
Part 2: Additional ASiC containers
---------------------- Page: 1 ----------------------
2 ETSI TS 119 162-2 V1.0.1 (2015-08)
Reference
RTS/ESI-0019162-2-TS
Keywords
ASiC, e-commerce, electronic signature, security
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2015.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
---------------------- Page: 2 ----------------------
3 ETSI TS 119 162-2 V1.0.1 (2015-08)
Contents
Intellectual Property Rights . 4
Foreword . 4
Modal verbs terminology . 4
Introduction . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 5
3 Definitions and abbreviations . 6
3.1 Definitions . 6
3.2 Abbreviations . 6
4 ASiC additional containers . 6
4.1 Introduction . 6
4.2 ASiC-S additional containers . 6
4.2.1 ASiC-S Time assertion additional container . 6
4.3 ASiC-E additional containers . 6
4.3.1 ASiC-E CAdES additional container . 6
4.3.2 ASiC-E Time assertion additional container. 7
Annex A (informative): Using ASiC with existing container specifications . 8
Annex B (informative): ASiC application to archival systems using ER . 10
B.1 Introduction . 10
B.2 Extraction of one single signed data from the archive . 10
B.3 Extraction of multiple signed data from the archive . 10
History . 11
ETSI
---------------------- Page: 3 ----------------------
4 ETSI TS 119 162-2 V1.0.1 (2015-08)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Electronic Signatures and
Infrastructures (ESI).
The present document is part 2 of a multi-part deliverable specifying Associated Signature Containers (ASiC), as
identified below:
Part 1: "Building blocks and ASiC baseline containers";
Part 2: "Additional ASiC containers".
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
Part 1 of the present multi-part deliverable, ETSI TS 119 162-1 [2] (ASiC part 1 henceforth) specifies the use of
container structures for associating either detached CAdES [1] signatures or detached XAdES [i.7] signatures or time
assertions, with one or more signed objects to which they apply and specifies a number of baseline containers that aim
to fulfil the common use cases and allows a number of options.
ETSI
---------------------- Page: 4 ----------------------
5 ETSI TS 119 162-2 V1.0.1 (2015-08)
1 Scope
Specific communities or use cases may have additional requirements that are not addressed by the baseline containers
defined in ASiC part 1 [2] that can be built using the building blocks defined there or additional ones. The present
document references such specific additional use of ASiC and aims to be used for containers that collects together
electronic documents including those supported by OCF, ODF and UCF describing how these container formats can be
used to associate digital signatures with any data objects in the container.
2 References
2.1 Normative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
The following referenced documents are necessary for the application of the present document.
[1] ETSI TS 119 122-1: "Electronic Signatures and Infrastructures (ESI); CAdES digital signatures;
Part 1: Building blocks and CAdES baseline signatures".
[2] ETSI TS 119 162-1: "Electronic Signatures and Infrastructures (ESI); Associated Signature
Containers (ASiC); Part 1: Building blocks and ASiC Baseline containers".
2.2 Informative references
References are either specific (identified by date of publication and/or edition num
...