EN 14382:2005/prA1

Safety devices for gas pressure regulating stations and installations - Gas safety shut-off devices for inlet pressures up to 100 bar

EN 14382:2005/prA1

Name:EN 14382:2005/prA1   Standard name:Safety devices for gas pressure regulating stations and installations - Gas safety shut-off devices for inlet pressures up to 100 bar
Standard number:EN 14382:2005/prA1   language:English language
Release Date:   technical committee:CEN/TC 235 - Gas pressure regulators and associated safety devices for use in gas transmission and distribution
Drafting committee:CEN/TC 235/WG 1 - Safety shut-off devices, safety relief devices and small regulators with or without safety devices used in gas transmission and/or distribution.   ICS number:23.060.40 - Pressure regulators
SLOVENSKI STANDARD
SIST EN 14382:2005/kprA1:2008
01-november-2008
Varnostne naprave za plinske regulacijske postaje in napeljave - Plinske varnostne
zaporne naprave za vstopne tlake do 100 bar
Safety devices for gas pressure regulating stations and installations - Gas safety shut-off
devices for inlet pressures up to 100 bar
Sicherheitseinrichtungen für Gas-Druckregelanlagen und –einrichtungen - Gas-
Sicherheitsabsperreinrichtungen für Eingangsdrücke bis 100 bar
Dispositifs de sécurité pour postes et installations de détente-régulation de pression de
gaz - Clapets de sécurité pour pressions amont jusqu'à 100 bar
Ta slovenski standard je istoveten z: EN 14382:2005/prA1
ICS:
23.060.40 7ODþQLUHJXODWRUML Pressure regulators
SIST EN 14382:2005/kprA1:2008 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 14382:2005/kprA1:2008

---------------------- Page: 2 ----------------------

SIST EN 14382:2005/kprA1:2008
EUROPEAN STANDARD
FINAL DRAFT
EN 14382:2005
NORME EUROPÉENNE
EUROPÄISCHE NORM
prA1
September 2008
ICS 23.060.40

English Version
Safety devices for gas pressure regulating stations and
installations - Gas safety shut-off devices for inlet pressures up
to 100 bar
Dispositifs de sécurité pour postes et installations de Sicherheitseinrichtungen für Gas-Druckregelanlagen und -
détente-régulation de pression de gaz - Clapets de sécurité einrichtungen - Gas-Sicherheitsabsperreinrichtungen für
pour pressions amont jusqu'à 100 bar Eingangsdrücke bis 100 bar
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 235.
This draft amendment A1, if approved, will modify the European Standard EN 14382:2005. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 14382:2005/prA1:2008: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 14382:2005/kprA1:2008
EN 14382:2005/prA1:2008
Contents Page
Foreword.3
1 Modification to Foreword.4
2 Modification to Clause 1, Scope .4
3 Modification to Clause 2, Normative references .5
4 Modification to Clause 3, Terms, definitions and symbols.7
5 Modification to 4.1, Basic requirements.11
6 Modification to 4.2, Materials.12
7 Modification to 4.3, Strength of housing.14
8 Modification to Clause 5, Functional requirements .17
9 Modification to Clause 6, Testing .17
10 Modification to Clause 7, Test and verification methods.17
11 Modification to 8.2.3, Documentation provided with the shut-off device .19
12
...

  • Relates Information
  • IEC 60300-3-7:1999

    IEC 60300-3-7:1999 - Dependability management - Part 3-7: Application guide - Reliability stress screening of electronic hardware Released:5/31/1999 Isbn:2831847974
    09-20
  • HD 571 S1:1990

    HD 571 S1:1998
    09-20
  • ISO 8130-4:1992

    ISO 8130-4:1992 - Coating powders
    09-20
  • HD 478.2.7 S1:1990

    HD 478.2.7 S1:2003
    09-19
  • ISO 8473:1988/Cor 1:1992

    ISO 8473:1988/Cor 1:1992 - Information processing systems — Data communications — Protocol for providing the connectionless-mode network service — Technical Corrigendum 1 Released:12/10/1992
    09-19
  • EN ISO 9013:2017/prA1

    EN ISO 9013:2017/oprA1:2024
    09-19
  • IEC 60118-6:1999

    IEC 60118-6:1999 - Hearing aids - Part 6: Characteristics of electrical input circuits for hearing aids Released:6/9/1999 Isbn:2831848075
    09-19
  • HD 280.3 S1:1990

    HD 280.3 S1:1999
    09-19
  • ISO 9832:1992

    ISO 9832:1992 - Animal and vegetable fats and oils -- Determination of residual technical hexane content
    09-19
  • EN 60188:1988/A1:1990

    EN 60188:1999/A1:1999
    09-18