|
SIST-TS CEN/TS 19101:2023
01-februar-2023
Projektiranje kompozitnih konstrukcij iz vlaken in polimerov
Design of fibre-polymer composite structures
Bemessung von Tragwerken aus Faserverbund-Kunststoffen
Calcul des structures en matériaux composites
Ta slovenski standard je istoveten z: CEN/TS 19101:2022
ICS:
91.010.30 Tehnični vidiki Technical aspects
91.080.99 Druge konstrukcije Other structures
SIST-TS CEN/TS 19101:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 19101:2023
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 19101:2023
CEN/TS 19101
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
November 2022
TECHNISCHE SPEZIFIKATION
ICS 91.010.30
English Version
Design of fibre-polymer composite structures
Calcul des structures en matériaux composites Bemessung von Tragwerken aus Faserverbund-
Kunststoffen
This Technical Specification (CEN/TS) was approved by CEN on 22 August 2022 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 19101:2022 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 19101:2023
CEN/TS 19101:2022 (E)
Contents Page
European foreword . 5
0 Introduction. 6
1 Scope . 7
2 Normative references . 9
3 Terms, definitions, symbols and abbreviations . 10
3.1 Terms and definitions . 10
3.2 Symbols and abbreviations . 21
3.3 Symbols for member axes . 46
4 Basis of design . 50
4.1 General rules . 50
4.2 Principles of limit state design . 50
4.3 Basic variables . 50
4.4 Verification by the partial factor method . 52
4.5 Design assisted by testing . 61
5 Materials . 62
5.1 Glass transition temperature .
...