|
SIST EN 1870-17:2012/kFprA1:2014
01-november-2014
9DUQRVWOHVQRREGHORYDOQLKVWURMHY.URåQHåDJHGHO5RþQHKRUL]RQWDOQH
NURåQHåDJH]DSUHþQLUH]]HQRUH]DOQRHQRWRURþQHUDGLDOQHåDJH
Safety of woodworking machines - Circular sawing machines - Part 17: Manual
horizontal cutting cross-cut sawing machines with one saw unit (radial arm saws)
Sicherheit von Holzbearbeitungsmaschinen - Kreissägemaschinen - Teil 17:
Handbetätigte waagrecht schneidende Auslegerkreissägemaschinen mit einem
Sägeaggregat (handbetätigte Radialsägen)
Sécurité des machines pour le travail du bois - Machines à scies circulaires - Partie 17:
Tronçonneuses manuelles à coupe horizontale avec une unité de sciage (scies
circulaires radiales manuelles)
Ta slovenski standard je istoveten z: EN 1870-17:2012/FprA1
ICS:
25.080.60 Strojne žage Sawing machines
79.120.10 Lesnoobdelovalni stroji Woodworking machines
SIST EN 1870-17:2012/kFprA1:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 1870-17:2012/kFprA1:2014
---------------------- Page: 2 ----------------------
SIST EN 1870-17:2012/kFprA1:2014
EUROPEAN STANDARD
FINAL DRAFT
EN 1870-17:2012
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
August 2014
ICS 79.120.10
English Version
Safety of woodworking machines - Circular sawing machines -
Part 17: Manual horizontal cutting cross-cut sawing machines
with one saw unit (radial arm saws)
Sécurité des machines pour le travail du bois - Machines à Sicherheit von Holzbearbeitungsmaschinen -
scies circulaires - Partie 17: Tronçonneuses manuelles à Kreissägemaschinen - Teil 17: Handbetätigte waagrecht
coupe horizontale avec une unité de sciage (scies schneidende Auslegerkreissägemaschinen mit einem
circulaires radiales manuelles) Sägeaggregat (handbetätigte Radialsägen)
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 142.
This draft amendment A1, if approved, will modify the European Standard EN 1870-17:2012. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has
the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland,
...