|
SLOVENSKI STANDARD
01-september-2021
Sistemi napajalnih razvodnic - 1. del: Splošne zahteve - Dopolnilo A2 (IEC 61534-
1:2011/A2:2020)
Powertrack systems - Part 1: General requirements (IEC 61534-1:2011/A2:2020)
Stromschienensysteme - Teil 1: Allgemeine Anforderungen (IEC 61534-1:2011/A2:2020)
Systèmes de conducteurs préfabriqués - Partie 1: Exigences générales (IEC 61534-
1:2011/A2:2020)
Ta slovenski standard je istoveten z: EN 61534-1:2011/A2:2021
ICS:
29.060.10 Žice Wires
29.120.20 Spojni elementi Connecting devices
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN 61534-1:2011/A2
NORME EUROPÉENNE
EUROPÄISCHE NORM
July 2021
ICS 29.060.10; 29.120.10
English Version
Powertrack systems - Part 1: General requirements
(IEC 61534-1:2011/A2:2020)
Systèmes de conducteurs préfabriqués - Partie 1: Stromschienensysteme - Teil 1: Allgemeine Anforderungen
Exigences générales (IEC 61534-1:2011/A2:2020)
(IEC 61534-1:2011/A2:2020)
This amendment A2 modifies the European Standard EN 61534-1:2011; it was approved by CENELEC on 2020-08-07. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 61534-1:2011/A2:2021 E
European foreword
The text of document 23A/903/FDIS, future IEC 61534-1/A2, prepared by SC 23A "Cable
management systems" of IEC/TC 23 "Electrical accessories" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN 61534-1:2011/A2:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022-04-29
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024-04-29
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CENELEC by the European Commission
and the European Free Trade Association, and supports essential requirements of EU Directive(s).
For the relationship with EU Directive(s), see informative Annex ZZ, included in
EN 61534-1:2011/A11:2021.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 61534-1:2011/A2:2020 was approved by CENELEC as a
European Standard without any modification.
IEC 61534-1
Edition 2.0 2020-07
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
A MENDMENT 2
AM ENDEMENT 2
Powertrack systems –
Part 1: General requirements
Systèmes de conducteurs préfabriqués –
Partie 1: Exigences générales
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 29.060.10; 29.120.10 ISBN 978-2-8322-8556-5
– 2 – IEC 61534-1:2011/AMD2:2020
© IEC 2020
FOREWORD
This amendment has been prepared by subcommittee 23A: Cable management systems, of IEC
technical committee 23: Electrical accessories.
The text of this amendment is based on the following documents:
FDIS Report on voting
23A/903/FDIS 23A/908/RVD
Full information on the voting for the approval of this amendment can be found in the report on
voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC website under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
_____________
2 Normative references
Replace:
IEC 60068-2-52, Environmental testing – Part 2-52: Tests – Test Kb: Salt mist, cyclic (sodium
chloride solution)
IEC 60068-2-75, Environmental testing – Part 2-75: Tests – Test Eh: Hammer tests
IEC 60112:2003, Method for the determination of the proof and the comparative tracking indices
of solid insulating materials
IEC 60127-1:2006, Miniature fuses – Part 1: Definitions for miniature fuses and general
requirements for miniature fuse-links
IEC 60269-1:2006, Low-voltage fuses – Part 1: General requirements
IEC 60529:1989, Degrees of protection provided by enclosures (IP Code)
[footnote text] There exists a consolidated edition 2.1 (2001) that includes IEC 60529 (1989) and its Amendment 1
(1999).
IEC 60695-2-11:2000, Fire hazard testing – Part 2-11: Glowing/hot-wire based test methods –
Glow-wire flammability test methods for end-products
IEC 60695-10-2:2003, Fire hazard testing – Part 10-2: Abnormal heat – Ball pressure test
IEC 61534-1:2011/AMD2:2020 – 3 –
© IEC 2020
IEC 60695-11-2:2003, Fire hazard testing – Part 11-2: Test flames – 1 kW nominal pre-mixed
flame – Apparatus, confirmatory test arrangement and guidance
IEC 60884-1:2002, Plugs and socket outlets for household and similar purposes – Part 1:
General requirements
Amendment 1 (2006)
[footnote text] There exists a consolidated edition 3.1 (2006) that includes IEC 60884-1 (2002) and its Amendment 1
(2006).
ISO 2081:2008, Metallic and other inorganic coatings – Electroplated coatings of zinc with
supplementary treatments on iron or steel
with the following:
IEC 60068-2-52:2017, Environmental testing – Part 2-52: Tests – Test Kb: Salt mist, cyclic
(sodium chloride solution)
IEC 60068-2-75:2014, Environmental testing – Part 2-75: Tests – Test Eh: Hammer tests
IEC 60112:2003, Method for the determination of the proof and the comparative tracking
indices of solid insulating materials
IEC 60112:2003/AMD1:2009
IEC 60127-1:2006, Miniature fuses – Part 1: Definitions for miniature fuses and general
requirements for miniature fuse-links
IEC 60127-1:2006/AMD1:2011
IEC 60127-1:2006/AMD2:2015
IEC 60269-1:2006, Low-voltage fuses – Part 1: General requirements
IEC 60269-1:2006/AMD1:2009
IEC 60269-1:2006/AMD2:2014
IEC 60529:1989, Degrees of protection provided by enclosures (IP Code)
IEC 60529:1989/AMD1:1999
IEC 60529:1989/AMD2:2013
[footnote text] A consolidated version of this publication exists, comprising IEC 60529:1989,
IEC 60529:1989/AMD1:1999 and IEC 60529:1989/AMD2:2013.
IEC 60695-2-11:2014, Fire hazard testing – Part 2-11: Glowing/hot-wire based test methods –
Glow-wire flammability test method for end-products (GWEPT)
IEC 60695-10-2:2014, Fire hazard testing – Part 10-2: Abnormal heat – Ball pressure test
method
IEC 60695-11-2:2017, Fire hazard testing – Part 11-2: Test flames – 1 kW nominal pre-mixed
flame – Apparatus, confirmatory test arrangement and guidance
IEC 60884-1:2002, Plugs and socket-outlets for household and similar purposes – Part 1:
General requirements
IEC 60884-1:2002/AMD1:2006
IEC 60884-1:2002/AMD2:2013
[footnote text] A consolidated version of this publication exists, comprising IEC 60884-1:2002,
IEC 60884-1:2002/AMD1:2006 and IEC 60884-1:2002/AMD2:2013.
ISO 2081:2018, Metallic
...