To modify the automatic start of a gasoline generator, the first requirement is to see if there are gear teeth on the side of the flywheel. If there are teeth on the side, it must be matched with the same starter and gear. like teeth. You should also consider repairing the starter. After installing these brackets, consider the battery and start switch etc. You can modify them however you want as long as you are willing to spend the money.
Where is the generator of the women's motorcycle installed?
On the left side of the engine cover.
This type of curved beam motorcycle generator consists of a stator coil and a rotor magnet. The stator coil is installed on the magneto cover and the rotor is installed on the left end of the crankshaft.
Engine speed is high, generally above 5,000 rpm. Power per liter (effective power emitted per literengine displacement) is large, generally around 60 kilowatts/liter, which shows that the motorcycle engine is very reinforced and the engine displacement is small.
In order to ensure engine cooling at low vehicle speeds and before starting, high-power motorcycle engines adopt a forced air cooling method that installs fans and air ducts and uses forced air to blow the cooling fins.
Detailed information:
The armature reaction magnetic field and the rotor excitation magnetic fieldA synchronous generator can be approximately considered to be distributed according to the sinusoidal law. The spatial phase difference between them depends on the temporal phase difference between the no-load electromotive force E0 and the armature current I. The armature reaction magnetic field is also related to the charge state. When the generator load is inductive, the armature reaction magnetic field acts as a demagnetizer, which will cause the generator voltage to decrease; when the load is capacitive, the armature reaction magnetic field acts as a magnetizer, which will reduce the generator voltage; the generator output voltage increases.
Baidu Encyclopedia - Generator
If the generator you are talking about is a magneto, it will usually be located in front of the right side of the engine.
For forced air cooled motors, the magneto stator is installed on the right side of the housing, the rotor isinstalled on the crankshaft, a fan is installed outside the rotor, and a fan cover is installed on the outermost side for protection (mainly made of pp).
For large displacement water-cooled engines, the magneto stator is installed on the right side cover and the rotor is installed on the crankshaft. You can see it by opening the right side cover.